Sounds good thanks guys. The motor seems to be in great shape. I was nervous about that. I bought it without knowing if jt would run. When i put...
A little background, I found an ad probably eight years ago for a dauntless enginge pulled out of a mud racing cj5. It was for sale at a junkyard....
I keep hearing and reading that. I had my buddy put a stethescope on the bell housing when i was driving we were pretty confident about it coming...
I have 225 v6 to ford T18 transmission. I filed, welded and drilled the bellhousing along with some parts from novak. Been a great setup for a...
I haven’t checked the motor mounts or tranny mounts. I put them on many years ago, but very low mileage. All off roading though. That’s probably...
I like that answer. Thumbs up
Hey guys, i just finished putting a new dauntless in my early cj5. I have a 69 jeep v6 that i drilled the bell housing and mated to a ford t18...
Thank you!!!! I was trying to find this seller on ebay but couldnt figure it out. Much appreciated!
Does anyone know where i can get good replacement fuel and temp gauges for my 69 Dauntless v6? Everything was working fine until my temp gauge...
Hello let me preface this with, i know nothing about motors except how to pull them out and put them in. I have heads that are “ported and...
This is excellent info thank you. I think i will go back to my stock 2 barrel. At least for now. Id love to leave the offenhauser intake and just...
This new to me dauntless came with a offenhauser 4 barrel intake and carter afb carb (9625s) I have researched the 4 barrel carbs on this forum...
Thanks a lot everyone!
Hello I have a new to me dauntless V6 with Offenhauser 360 intake. I am trying to hook up the cooling system but I have no idea where the old...
I did do one side at a time. The side that trickled out, i tried dumping a shot glass of marvel mystery oil down... Neither side seems like the...
I fired up the wood stove and pulled both rocker arm assemblies. Pulled the distributor and hooked up my hole hawg via old distributor shaft. The...
Thank you everyone for the advice i’ve never had to deal with this before and you’ve been very helpful. Can i pull the three bolts for each rocker...
The valve that is directly next to where the oil filter screws on...is it suppose to be open or closed? I found it sideways jammed open. Of...
Ive been spinning the oil pump with an old distributor shaft for several nights now. After packing it with vaseline, i finally got good oil...
It seems like 70 psi isnt the end of the world at start up. This engine sounds increadible, im wondering if it is getting oil and im just not...
Separate names with a comma.