I seem to remember a mod that extended the vent and turned it down the carb throat. Does it work and will it need soldering.
Trac loc exploded last week taking out everything in the carrier. Will rebuild with Yukon r&p and am thinking about the Dura Grip posi. Anyone...
Going to do this conversion when I get to Washington. My question is can it be done in the jeep?
Anyone one else have issues with this thing? I remember this happening the first time I rebuilt this trans. Trashed it and had to buy another. Any...
Needed the wife to come get me in Pete the other night and she couldn't get him started. So the next day I tried myself and immediately noticed...
Had a couple of wind free days so I checked the mileage today. The rebuild has given a substantial increase in mileage. 20.6 mpg all hwy (ex for...
Well I took Pete in to have the alignment measured today. Castor settings were +2.6* L and +2.2* R. This is with a 4* wedge sitting on 3" Black...
to the carb kit. Anyone have float levels and measuring points for a brass float?
After my D30 swap I was faced with a trip to Idaho and a need for wedges immediately.I got a set of 4° steel wedges from Bluetorch to add to an...
Anyone ever looked into machining the tubes so an axle seal can be installed? One of the things I've been pondering lately (popped up when I was...
Looking for a source. They need to be about .5" longer than stock and that .5" should be in the shank if at all possible. Anyone have a good source?
Maybe through the vent or inlet? I want a fast clean startup and everything is dry.
The new rocker assemblies and push rods arrived yesterday so I may accomplish the rest of the top end this weekend. I'm unsure about the best way...
I could send a pm but I think others might like to know also. Chuck I know I asked a couple of years ago in general. I'm at the point to do this...
A little wet yet to move the block outside so starting with cleanup this morning. A trick my Dad taught me was to use oven cleaner. Gets rid of...
Got the block and crank back from the machine shop today. Good news, everything is still standard, only honing and polishing the crank. Hot tank...
I seem to remember someone found an alcohol safe kit for the 2g. Anyone got the number?
Block will be done mid week. Everything else is here ready to be installed. [IMG]
3 to choose from. Sealed Power, Keith Black Silv-O-Lite, or Omix are the choices. I've ruled out Omix. Any comments on the other two? Also a...
My pickup is down so I'm weighing the possibility of loading the block in the hatchback.
Separate names with a comma.