I searched a little bit but was wondering if anybody had better luck with one brand or another of replacement 76+ steel windshield frames?
Going to look at a 64 Cj3b close by this weekend when i can get with the guy. Im sorta familiar with later Cj's so is there anything obvious to...
How heavy is a 76 Cj5 steel body tub? Just trying to figure how much help i will need to remove it. Thanks
Here are a couple of pictures of an front spring hanger that needs repair on a frame im working with. Im just trying to get some ideas of a...
Ive been searching and just wanted to ask.. On frame metal that has been sand blasted would you still use POR15, rust encapsulator, or somthing...
I have purchased a 2v intake for my 258, but it has what looks like water inlet/outlets on it and i was just wondering how these were used. It was...
Took my Odomter/gauge cluster out to diagnose it..after some study it seems i have an aftermarket gauge cluster. Im not seeing anywhere that...
What is an acceptable "range" of RPM's for a 258 on the highway for extended periods? Ive seached some and seen anywhere from 2500 up to 5k. This...
Anybody know a good online reference to overhauling a T150 tranny?
I have somehow scraped my radiator with my fan blade. This causes a rather unsightly water fountain on that side of the new radiator i have.:oops:...
Today i have been having trouble with my 3spd T150. Seems like when i shift from second to third it doesnt just slide in, it grinds going in a...
Are there any significant differences in the centered Dana44 in Jeep CJ's from 72-75? Brakes or bearings maybe?
Anybody got suggestions on better than average motor mounts? I got some at local parts store just a little while back and it feels like one is...
Id seen some info covering this Dana30 upgrade once but i cant find it anymore, is there a site, or any information here that ive missed already?...
While doing some wheeling this past weekend.. I heard this awful noise coming from the front end. Well when i got to where i could check it out I...
If you have a locker in the front axle and manual hubs.. and only one hub locked in, what actually happens? Only one wheel pulls or neither or...
What proportioning valve do i look for after i have the actual disc brake setup to swap onto my dana30? I know a 77+ will work but are there...
Im new to the locker thing.. is this considered a pretty good locker for a CJ dana 30?
How much more trouble to put a NP435 in an intermediate than a T18? I Have the T150 now. Having trouble finding the T18 without spending more...
I know the over all length is different, but where is this difference at in the 76+ frame and how much? thanks.
Separate names with a comma.