Tim i can appreciate the OEM fit but I have been having trouble finding one that is in "good" shape that isnt already on sombodys "driving" jeep....
I searched a little bit but was wondering if anybody had better luck with one brand or another of replacement 76+ steel windshield frames?
Silly question, if the 72-75 dana 44 was slightly offset did it not line up with the dana 20 of those yrs? Was the driveline offset also.
Going to look at a 64 Cj3b close by this weekend when i can get with the guy. Im sorta familiar with later Cj's so is there anything obvious to...
Thanks..I have already had a chainfall in the rafters for helping with my T18 tranny install R) The engine hoist sounds nice just because of the...
How heavy is a 76 Cj5 steel body tub? Just trying to figure how much help i will need to remove it. Thanks
The rest of the frame is in almost perfect condition, very little rust also. Thats why im trying to fix this problem. The guy I got the frame from...
Here are a couple of pictures of an front spring hanger that needs repair on a frame im working with. Im just trying to get some ideas of a...
Ive been searching and just wanted to ask.. On frame metal that has been sand blasted would you still use POR15, rust encapsulator, or somthing...
Thanks a ton! Looks great to me!
any kind of adapter needed to go from 81 or newer 258 intake to MC2100?
Hey, any chance you have a frontal shot of your jeep to show overal width? Those 33x10.5 MT's will probably be my next set of tires when i wear my...
Thanks a bunch! Im just trying to go to a 2brl carb. If cold weather starts are to be helped i will try it after i get everything setup. Cant hurt...
I have purchased a 2v intake for my 258, but it has what looks like water inlet/outlets on it and i was just wondering how these were used. It was...
I am watching with interest too.. i have one of these. It came with my axle and i havent pushed it to hard yet.
Took my Odomter/gauge cluster out to diagnose it..after some study it seems i have an aftermarket gauge cluster. Im not seeing anywhere that...
Im not much of a expert but the 44/30 seems best for trail duty. Only other thing.. swap knuckles from the 30's to get the the bigger disc...
What is an acceptable "range" of RPM's for a 258 on the highway for extended periods? Ive seached some and seen anywhere from 2500 up to 5k. This...
How well do these kits fit the floor pan? How much modifying?
Thanks for the link Tim..I am passed due to get one of those..I Know:oops:
Separate names with a comma.