Does anyone have any experience with a shop in Colorado along the front range that does a good job rebuilding the dauntless engine? Thanks in...
I am wondering if I can move a new gear set that is currently in a wide track Dana 30 from a later-model CJ over to a narrow track Dana 30 with...
I have a 68 dauntless, with engine stamp of 991503 and DPH. I have been chasing down a clattering noise coming from the distributor shaft at...
I have been restoring a late 60’s Dauntless V6. It has good compression on all cylinders and is tuned and running well. I also have a new timing...
I bought this Dana 30 awhile back with the intention of swapping it with my Dana 27. The seller told me it was 4.88 gears which is what I needed....
I picked up a transmission jack from Harbor Freight and successfully dropped the transmission this morning by myself. As suggested in other...
Does anyone know the Timken part numbers for the D44 carrier bearings/races? I am replacing them on a Powr-Lok in a 69 CJ-5. Thanks! -Bill
This is my 69 CJ5. It has Rugged Trail springs that were put on many years ago by the PO. It currently has 31X10.5 tires and I would like to...
I bought the rear hub puller from Kaiserwillys.com and it worked like a charm. I've pulled the hubs and brakes off and am wondering what the best...
I'm finally getting around to putting 11" brakes on the rear Dana 44 axle of my 69 CJ-5. I bought these backing plates a couple years ago, but...
I have a bent rear Dana 44 axle on my 69 CJ-5 that I will be swapping with one from a 66 CJ-5 that has the same 4.88 gearing. Is there any...
Removed the Steering Wheel today from my 66 CJ5, V6. I used a steering wheel puller I purchased at Harbor Freight for about $40. It worked...
On my 69 CJ5, V6, PO had removed the horn wire and covered the hole in the bottom of the Ross box with something that looked like JB Weld....
Will a steering wheel from a 62 CJ5 work on a 66 CJ5? I realize the horn style is different, but I want to get rid of a smaller aftermarket...
This is the stock air filter I have on my 66 CJ5 with the V6 and I am trying to figure out where the small vacuum hose on the bottom of the filter...
Did a compression test on my 69 V6 just to satisfy my curiosity. PO, who was the original owner, told me the jeep has less than 30K miles on it....
installed the Summit heater last weekend following the advice of so many on this forum. The instructions say it is important to make sure the...
I thought someone might benefit from my recent :v6: radiator replacement in my 69 CJ5. I installed an American Eagle aluminum radiator, AE2374,...
There is a rectangular piece of metal bolted to the top of my dash that I don't know what it is for. It has a bolt on each side and there is a...
Here are a few photos from a pet project of mine. I always wished I had a dipstick on the transmission so I could easily confirm my oil level. I...
Separate names with a comma.