I have a clackity clack noise coming from my distributer . Upon inspection I have some slop up and down in the distributer shaft. I removed the...
Well I've been token on the crack pipe and I have a new project in mind. I am looking for some pics of a frame stretch. I did a search and most of...
I just picked up a 74 and I can't tell if its a 232 or 258 according to the 74 manual the engine build code should be an "A" for the 258 and a "E"...
What is this bracket or trim piece above the gas filler I have never seen one before anyone? what would it be for? This is on the 65 tux park I...
My transfer case leaks, I know big deal they all leak:roll:. I know the trans and transfer case share fluid my question is can the leak in the...
Has anyone run across a source for parts to rebuild these ? I would think they were used on a wide variety of vehicals not just the jeeps.
What was the gloss level on the original black windshield frame, flat, semi or full gloss?
I just got a great used top for $125.00 including all the hardware. Only problem there is a small tear in the rear plastic window not bad but I...
Is there a quick easy way to tell the difference between a 55 to 75 top and a 76 and up? I found a used top but the owner doesn't know what year...
OK my eyes are sore from reading searches, I just bought a set of 4.5 x 16 stock rims can I fit a 7.00 x 16 on it? Or a 225/75/16 ? Thanks Steve
I am having a tough time finding used stock wheels that will fit over 11" drums and I am trying to avoid going with the new Omix wheels at $180.00...
Question for those of you running the Wildwood hydraulic cylinder. two things How much travel should I be getting on the pull cylinder? I seem to...
Had a little problem with the oil pump but got that fixed. Little :v6: runs greatR) small timing adjustment and that was it, started right up....
Ok just fired up my:v6: for the first time after rebuild. Started right up and blew the oil filter I mean blew out the seams. put on a new filter,...
I have a 69 225 and I have the distributer from a 198 that fits the 198 and the 225 up to 66. Any problem using the older distributer in the 69...
Don't leave the timing cover with freshly packed vasolene in the oil pump out in the sun.:oops:
I am finally finishing up my motor and and getting close to starting so i am double checking a few things. First number one cyl. is pass side...
I am rebuilding my 2g and when I cleaned up the jets they had a 54 stamped on one and a 49 stamped on the other I assume this is the jet size? i...
When building a dual exhaust do each of the mufflers have to be the same or close to the same distance from the manifolds?
My buddy just picked up a 53 m38a1. it has the flathead in it I thought the m38s had the f head. Anyone have any info on this? Steve
Separate names with a comma.