This winter has just flown by, .. I had so many plans and work I wanted to get finished before spring. BUT, I'm only 27 days away from when I...
Desertrunner, off topic but would like to see a few pics of your on board air install. Where you put compressor/tank etc. Starts with the air...
So, .... while part of me works on the Dana 44, another part is working on modifying the shift rails in the D20 xfercase, and then there are the...
Has anyone put M20 backing plates on a D44? Or can the D44 plates be modified to accept the M20 cables? I'm getting ready to work on my D44 and...
So, I've looked for information on removing the shifter interlock from the Dana 20 transfer case. From what I have found the interlock or pills...
[MEDIA] $260 Thought I might try this. Since I have already put in an oxygen sensor for the fitech, it's just a matter of the carb plate some...
It is time to address my body repair. I have the rear wheel well panels and the front side panels. but attaching them is the issue. The videos I...
I have a 304 V8. The hose coming from the back of the intake Manifold and goes to the heater core, .... top fitting or bottom fitting, and the...
I seem to have lost one of my wheel cylinder Pins/Link. the only replacement I can find is Omix-Ada 16751.02 listed for 10" brakes, I have 11 x 2...
I am looking in to re-engineering my rear axle. The first step along the path is to get the dimensions ( inside dia and outside dia.) of a Dana 44...
Since I have little that I can do, I figured I would start a parts list to fix the Jeep. 1st on the list is to get the rear axle to the same gear...
Forget project creep, .... how about project Explosion. When I put the T18 4 speed in my 78 CJ5 I used the T150 bell housing and bearing retainer...
I am I am looking to replace my stock AMC model 20 rear axle with something new, I looked at curry but they only sell 82 to 86 and I don't know...
As mentioned is other posts, the car hauler needs some TLC. I have already replaced the 7 pin connector, and repaired the wiring to the electric...
Besides JB Custom Fabrication, what other options are there?
This may be a shot in the dark, but I thought I would try. My AGR Super box 1 P/S box is leaking from the steering shaft input. I contacted...
Since I now have the triple belt pulley's installed I wanted to put matching belts on the P/S pump. While on my last trip I lost a belt so I...
It has been over 20 yrs since I installed a 4 core radiator in the Jeep. In preparing to leave, I have had several problems, the worse of which is...
This is going to be a 5 month thread, I will be trying to get as much done as possible before heading back out west. I try to go out every year...
I have been getting things together to start this conversion. The engine, as it sits now is an AMC 304 Bored .030 over, balanced. Of course that...
Separate names with a comma.