Hook Up, Buckle Up, Shuffle to the Door ......... I am packed up and ready to go. I am headed to Az, Ut, Nv. Due to health issues, this may be my...
Went to take the Jeep for a test drive, decided to clean the windshield, broke the drivers wiper....... :steamed: I said FINE, went to tell the...
Well the Jeep is almost ready. It needs a couple of test runs and an oil change. [img] And I need to sleep for a week. :coffee:
It's been a fiasco with the master cylinder, the one I bought on flee bay was incorrect, and the first 3 that I got from Autozone before they...
Well, ... today has been frustrating, I had to put new valve stems in two tires on the Suburban. Then I had to replace two manifold exhaust...
Pay attention to your rim back spacing. The first set of white spoke Wagon Wheels I had came with a back spacing of 1 3/4". Years later I bought...
Got the new U bolts installed and the leaf springs bolted up. I also got the air tank reinstalled and plumbed. [IMG] [IMG] and last I got the...
Got the sending unit sealed, and tested, ..... it doesn't leak anymore. Finished spraying Surface Shield on the underside of the back half of the...
I got the gas tank dropped, the Moeller sending unit is leaking when the tank is full. It leaks out the top, the square area in the pic. I have...
I would love this , my body is in really bad shape, ..... but by the time you calculate gas, I'd wind up at $3000 in total costs.:cry:
This winter has just flown by, .. I had so many plans and work I wanted to get finished before spring. BUT, I'm only 27 days away from when I...
I'll say it, No Title, Max $500
Yep, sounds good to me, I also extended the spring bolt by putting a drilled out nut on the bolt. It worked fine , now I just need to wait for the...
More work, I noticed there wasn't an axle breather, there were two 1/4x20 tapped holes, one on each axle tube. The Pass side hole is for mounting...
All Right,..... 1st just let me say the Bestarc 500DP is awesome! after I put it all together, no two connections were the same. I am cutting...
I got the 3.54 ring gear installed on the Tru Trac carrier. Then after many trials and errors, got a backlash of .006. Ran a pattern and it is in...
BTW Jam, :wel:From Pa
Timken 9912S The "S" seal has an outer seal for better, ...... a ....seal :coffee:
Desertrunner, off topic but would like to see a few pics of your on board air install. Where you put compressor/tank etc. Starts with the air...
I first installed mine, when I got my MileMarker hydraulic winch. After the winch died, I kept the throttle, it's really useful [IMG] [IMG]....
Separate names with a comma.