club guy is shopping PM me with a number for his number thanks only TM9-871A TECH MANUAL SNL G-747
My steering "sticks" then turning left and way too much wheel "slop" or play now. What IS failing? By "slop" or play to describe the issue when...
I found a cross reference and need an answer please. 10 INCH DRUM
I think the parts guy is confused AGAIN. Rear wheel cylinders are 13/16 inch ID bore and have a straight along the axle thread for the nipple on...
replace the three wire Motorola alternator question I connected the three wires of the external regulator to the alternator correctly what is the...
I want to go to 10si/12si internally regulated single wire. We have three circuits here: Start AND Run AND Charge. I am doing this because of...
Will anybody offer a fail proof schematic, I understand remove the external regulator and Motorola alternator. Replace the Motorola WITH the 1...
looking for a vendor
FSM QUESTION
Planning on a change to a 1 wire from a generator. What did you make, so I have a better clue please.
Have this idea that there is never enough fuel capability in a 2a , the tool box top under the passenger seat is in poor condition, new to me...
How many studs are on the windshield frame to attach the canvas top to, on a 1941 thru 1945 military jeep?
Found a site MADEINCHINA.COM, real surprised there. Their intent of the site is to offer sales leads for sellers to us.
I have a line on a $100 winch that requires a replacement solenoid. It also needs a cable too. It is rated at 8000lbs. I just got done writing to...
I have been messing with this for several weeks now. Recharged the battery charger today. replaced rotor cap and distributor cap today, coil,...
I have to make this change soon and I want to change to studs and nuts. I cannot find a reference. Thanks Dale
If you have the four thread and nut poles on the back of your starter switch; STart goes to the solenoid of the STARTER (the small guy on top of...
top hose to center of radiator CJURH-V6 NO BRAND NAME Lower hose from...
t86 is out finally, I had to wait for the snow for some reason, will a t90 repair kit work? What throw out bearing part number please. Help?...
I do not have the old tub to check my guess. I cannot find specific answers in the posts for their exact locations. I do not want to guess....
Separate names with a comma.