Why not put in a modern fuel injected 4 cylinder? Of course when the hood is opened it's not going to look retro but it would be effecient,...
McMaster Part Number: 90281A112 1.79 each There not exactly what your looking for but should work (course thread on both ends). Personally I...
I'm thinking really it should have two snap rings. One inside of the hub/driveflange to prevent it from coming out, and one on the outside to...
That helps out alot. Thanks. Are there snap ring grooves on them? I so were are they located?
I'm going to be converting an axle from a 65 to full float in the somewhat near future. I looked at the write up in the tech section and plan on...
I'll be cutting the shafts and splines myself. I have all of the stuff to do the shafts, as I do custom axles for local guys on the side. I'm...
This is probably a little off topic but is there a better/more readable picture then whats in the tech section with the dimensions for machining...
I'm bringing this to the top for you Hans. Give me a call when your ready to start getting things finished up on this thing. Anders
Any progress this weekend? I've been keeping an eye on your build. Your lightning pace has been inspiring me to work on mine (as well as a...
Got them if you want $15 plus shipping PM me if you want. Anders
PMed you a link to a 4BT.
Here is a link to what I like, have personally used, and installed on other Jeeps. It is very effective IMHO....
X2 need we say more? $1100-$1500 which includes tieing it in to the floor is a good price if you ask me. Be sure that the design is good and...
I did some research into this a few years ago. At that point in time none of the other Fiberglass body manufactures did CJ-6 tubs or even had a...
Did the guy selling scratch and dent frames not have any decent ones or did you not find him? Not a problem, reception there is always...
Yep, it is a great product. I have yet to learn all of it's features myself but what I use of it so far it works good. Mike you haven't...
Nice project so far. It's looking good. With the amount of weight it sound like you are planing on putting on your horses you may want to put...
Waggy ends are differant then the older Jeep/scout ends. It's a good idea Dan. You don't really need a CNC for it either, just a decent lathe...
Run it. Even thought it is a used set of gears do a standard break-in procedure on them (they should be available on Randy's site). Once you get...
Take a picture of were the pinion marked the gear after your marking compound. That is useually a little easier to read. It doesn't look too...
Separate names with a comma.