The idea is that the lump of brass (I use a square head brass hammer) acts as a heat sink, so the heat stays concentrated right where you want it...
Here's the mount on the CJ6A, BTW - http://home.earthlink.net/~militoy/images/HPIM2483.JPG
Most of the aftermarket ones, and many OEM ones have the same pattern. The ones on our CJ6A are from a Landcruiser chassis I have - they bolted...
Looks like the issue has been pretty well covered - what you're describing is a float level problem, plain and simple. What I'd like to know is -...
What it means, is that your ignition is running off the battery only, when your #2 wire is getting no power. Your 15V output is probably due to...
I bought a set from AV Equipment, and they were something like 1/4 - 3/8 thick, if I recall. I have a few spares I could measure tonight, if no...
Those little air horn compressers are a little shy on volume, and not usually made to run constantly. We scrounged an air-ride suspension...
I have my Hi-Lift mounted on a tow bar that I keep on the front of my flattie, unless I'm running in a parade. I welded 3 long wheel studs to the...
I tie terminal 1 thru an idiot lamp to switched ignition, terminal 2 thru a fusible link to the starter (+) terminal, and the BATT terminal thru a...
Many years ago I was involved with off road racing, and we ran a great big idiot light along with the gauges. The lamp was a warning for both oil...
Thanks for the replies - I guess maybe it's original then, and we'll just have to tweak it to make it more comfortable.
We're using a pair of medical aluminum oxy tanks, because they're lightweight, easy to mount, and almost free. The pancake tank would likely fit...
The gas pedal on our 66 CJ6A looks to have been replaced by a later model pedal. Is the 66 V6 pedal supposed to hang from above, or should it...
Nice mount. I've got some commercially-made ones of similar construction on my sandrail. I also use a form of velcro to mount my GPS and radio...
I've seen Phillipines aftermarket replacement body tubs that have a lot of the same features. I'd guess that someone had a 60 CJ5 with a totally...
I've got one almost identical to it - Mine's made out of a 30's Chevy 1/2 ton bed. Is the axle made up of a welded-up front end (hint: look for...
As Walldog posted - there's no magic to the Gama Goat lights - you have a simple wiring issue. Your best bet tracking the problem down is to use a...
My son did the same job on the CJ6 today. Kit was $20 from Antelope Valley Equipment - but they are local, so no shipping costs. He was "easily"...
Thanks - I think we will run it without a return loop, as the tanks aren't fitted for it. If Kaiser bought the design outright, what kind of V6...
Thanks for the quick replies - I was under the impression that Kaiser was licencing the 225 Dauntless V6 from Buick, and that the one in the...
Separate names with a comma.