Completed the front driveshaft seal. Tough time getting it out. After trying to pry it out, I screwed 4" deck screws into the seal and used a crow...
Completed the front driveshaft seal. Tough time getting it out. After trying to pry it out, I screwed 4" deck screws into the seal and used a...
Anyone ever put a vega motor in a CJ5 with a three speed and a twin stick transfer case?
Buy 15" wheels and put 31X10.50X15 on it. There are more choices because this is a more common size. Check out Cooper. Same quality a BFG and...
Hansh Did you use the double seal? Does a double seal set up remove the need for the felt seal?
Good idea on the vice grips. Any other hints for leak prevention without removing the case?
Yes, for the money you cant beat the stock set up. I am a moderate 4 wheler and I drive it on shrt trips around town (55mph and lower). It...
I thought about screwing screws in it on each side of the seal and then using a crow bar to ge the seal out?
Everyone recomends discarding the 9" brakes but properly adjusted with good servicable parts they stop just fine. They are not nearly as powerful...
Thanks. Excellent advice. I look fwd to the part #. Can you install two seals back to back? I though I remember someone writing about...
Mine is stock but I rebuilt the brakes (all four wheels), new shocks and a 2" lift (includes 4 new springs) and installed a steeing stabilizer...
I forgot to add that I am trying anything NOT to pull the tranny or transfer case.
I replaced all four cylinders, brake linings and hoses for less than $200. Make sure you turn the drums to ensure a good braking surface. Worth...
I am hunting down a 90 weight leak and I think I have found it to be the output shaft (front drive shaft seal). It has always leaked oil from the...
Mine has the three inch air filter and it works well. Aftermarket at NAPA.
Where is the vent on the TC?
Was it difficult to get the drive shaft knuckle off the spine?
Has anyone replaced the oil seal on the front output shaft on the the transfer case (twin stick)? It looks like this can be done without removing...
Yes, that is where it seams to be leaking after cleanning and looking for drops. I am sooooo glad it will not require a tranny/tranfer case removal.
I cleaned the transfer case off and found the leak to be in the front out of the driveshaft seal. Is this common?
Separate names with a comma.