Other than the fact that its sticking out and banging you in the knee?
Only trouble with this is that my dad's VW Thing and my Karmann Ghia both run extremely rough on high octane gas. We tried running Super Unleaded...
The Tux-in-a-barn is a '63, and its tailgate had no stamp.
Fuel pump working properly? Edit: Could also be a clogged fuel line. How long have you let it sit?
Hell they are (quoting because I saw it quoted on a later page and felt it needed addressing). I've seen a lot that could be partially engaged,...
Just my thoughts- I really don't like foot pedal e-brakes, especially if they have a "stomp to release" mechanism. I can't always tell if they're...
What kind of gauge is that you've got in the input shaft?
Ok, which surfaces are the "machined surfaces"? [IMG] And here's the pic I should've provided at the opening of the thread, just so we could all...
We don't have air in the barn (and usually not electricity), and I haven't been able to find a shop that'll do it affordably. Guess I'll be trying...
So I've got my front hubs off the spindles at long last. As we've all seen, they're really flipping rusty, and I want to de-rust them and get them...
If the wire in the column is broken, you might be better off replacing the whole steering wheel switch setup with a dash switch.
Is there any ductwork under the cab? And if so, can you get a picture of it?
See, that's why I'm not too keen on going with an electric conversion. Nobody makes a motor that you can just drop onto a transmission. You always...
Hell with pics, where'd you get an electric motor that can drop onto a T-84? Or did you replace the whole driveline?
Anyone care to explain what's so hot about an I6 engine, and why everyone rushes to suggest them over a V6? I know that they were "special"...
Ok, so we have a thread on stands but not on jacks. The Tux-in-a-barn has a record three attempts at jumping off both a scissor jack and a bumper...
The "new paint" is pretty much spot-on to what I found underneath the windshield frame trim pieces. Fairly dusky, but still recognizable as pink....
Might want to get a reprint FSM and chuck that Hayes or Chilton's manual. Those are loaded with misprints. My personal fave was an electrical...
Weren't the original V6 engines mated to T-98 four-speeds? Although a T-90 should work as well if you get the longer input shaft and adapter...
[IMG] FINALLY got the hubs off. Here's the bare spindle, on the passenger side- that bearing cone is stuck on, so I'll have to get a jaw puller...
Separate names with a comma.