Hi all, I seem to missing my reference material to put the self adjuster setup back on correctly. Does anyone have any pictures of their set up?
Hi all, haven't been around these parts recently. Hope everything has gone well for you folks. I recently have needed to change the u-joints...
Hi all, so I am in the process of reassembling my T-14 and its been some time, parts on the bench have gotten all sort of shifted about from when...
Hi all, I'm putting my T-14 back together mostly with NOS parts and re-using gears. I have a few questions concerning re-using old gears/...
Hi all, I'm servicing the T-14 that I have as a core currently and have come across quite a few hurdles only to run in to more! I need to...
Hi all, Going through my rear axle today, noticed that when I turn the rear hub by hand theres a helacious grinding noise...but when I turn the...
Howdy howdy! I just wanted to post up some bench seats I picked up out of a 1964 Tux Mk. IV. They came out of a green tux in the Tricities...
So I've been doing some research and using my parts manual to boot...and come up with an 807478 for the V-6 CJ sector shaft. I purchased an...
Hi all, I am tearing down my spare V-6 ross box and prepping it for a full rebuild. Does anyone know of a non-invasive way to remove the...
Hi everyone, I dont know if this is a silly question or not, but does anyone know of a proper grommet that will seal up the hand brake line at...
Hi all, I dont have a master parts list and need to know if there is a different part number between the clutch cross shaft on the V-6 or F-4...
I dont have a parts book to know the number, can anyone look it up in their manual?
I've been doing a lot of research into the short link on the lower mounted wiper linkage set up and I've noticed that a lot of people are cutting...
::this post doesnt have any pics:: Hi all, So I just went through and did a clutch job; I've reinstalled everything correctly as per the...
So, I removed my transmission and t-case a while ago...it had a 1/4" width steel plate between the cross member and frame rail on one side along...
Hi all, I have been working on a 1969 Jeep CJ5 with the Buick V-6 225 for about 2 years now. I'm currently about to do a clutch job and I...
Where to start...A while ago the P.O. decided to put a patronix ignition in the delco distributor, which served me well for a while but I decided...
So I have come upon this issue with my T-14 and the accompanying cross-member. Apparently the holes that I had marked as the original ones from...
So is it standard for the rear brakes to have more pressure going to them than the fronts on the V6? I took it the 5 to a break shop to get the...
So I have still not resolved this issue and dont really want to take it to a pro shop and pay for what I could be doing. The you tube link is...
Separate names with a comma.