I thought I had posted mine before, but here they are again since I don't see them anymore. Early version 1968 CJ5 with 225 V6 - presently...
There are two accepted ways to install press fit pistons. The pro shops with lots of capital investment use special press tooling to align the...
I built a fixture to hold the piston that included an adjustable stop to keep from over inserting the piston pin. Then I do the same as you...
I would pull it and have it cleaned to see what the real damage is. It doesn't look too bad from the picture, certainly nothing a properly fitted...
Evening folks, If you're patching holes, the best way to prevent blow through is to hold a chunk of copper behind the weld. I use a piece of...
Well, I don't know if I count. I took a '79 CJ5, lengthened it 20 inches to make a CJ6. After getting two '68 CJ5s, I swapped in an early CJ5...
Separate names with a comma.