Haven't found any for a jeepster, but I did find some for a scout that might work and then I found this on ebay 304 Stainless Steel Filler Neck...
That is exactly what I needed to see and exactly what I thought was happening! Thanks Jpflat2a! What does it list for a part description for...
Got a 1970 Jeepster Commando work project. Its a Commando body on a JK chassis with a chevy LQ4, auto trans, atlas drivetrain. Needless to say...
I would definitely mount it low between the framerails if you can. You can check my build thread here for mine, "just a small project", it should...
When I did my chevy front 44 I cut it down to 58" wide width. I had currie cut and respline my shafts, I believe they were charging $70 a shaft...
The HO head flows better=more power. If you decide to go fuel injection, the HO injection system is better. The non-HO will work, but if you...
I'm no expert, but they all appear to be the same thing to me. The last two are actually made by the same company CCH or Clearwater Cylinder...
My bad! Didn't know that was banned. Oh well! Kevo
No, a stroker uses the 258 crank and rods in a 4.0 block. The 258 has a longer stroke and the 4.0 has a bigger piston bore. It sounds like...
Honestly the spring would probably snap at some point before the hanger comes off. A long time ago I got into an accident in my toyota, oddly...
How well does yours hold on an incline? I take it it is hooked up to the stock foot pedal? Mine in the buggy works ok, it needs more leverage....
Looking really good! At times I wished I had gone this route instead of how I did, but there is allways time to build another! Hopefully I'll be...
The drivetrain changed a bit over the years. It was originaly a 75 with a 258, T18, D20 combo. I wheeled like that for awhile, eventually...
Here is a pic of when it all started. Just found this in my toolbox. I believe this is the day after I brought it home. I believe this was...
Done, sort of. [IMG] [IMG] [IMG] I still have the spare tire carrier and roof rack to paint. I haven't installed the center console yet...
I'll just put some teaser shots up here. [IMG] [IMG] Kevo
Perfect! They have a "pivot rebuild kit" that'll work just great! Thanks rusty! Kevo
Is there any place to get the plastic bushings for the bellcrank in the clutch linkage? Mine are basicly shot after 30+ yrs of abuse. I can buy...
Now, when you think your actually done with a paint job, get out your flashlight and start finding all the spots you missed. Used another spray...
Almost done with paint! I'm starting to think I should just pay someone to do this for me! I'm really burn't out on painting. [IMG] Kevo
Separate names with a comma.