I'm going to install a distributor in the Hurricane and know that #1 cylinder should be at TDC. If the timing marks line up, then #1 cylinder...
So I decide to do a minor tuneup and can't get the timing set, no matter which way I turn the dist the timing marks don't line up. I'm thinking I...
The second Pertronix for my Hurricane died, I like not having points but the thought of spending another $100.00 doesn't sit well with me, the...
When I took the side cover off the block to adjust the exhaust valves I noticed that the bolts holding it on were barely tightened. Now when I go...
When I drive the Jeep the speedo reads erratically. If I am in third gear and have my foot lightly on the accelerator pedal it reads close to...
I installed a dual reservoir master cylinder from Herm's in the Jeep. Additionally I put a new exhaust system in it. After both it turns out that...
I am converting from the PO electric fuel pump to a new mechanical fuel pump. I read somewhere about needing spacers for the new pump to adjust...
When I bought my Jeep it had a header on the engine and a homemade exhaust system. I decided to get a new exhaust manifold and exhaust system from...
I'm embarrassed to ask but could someone post some pictures of the routing of the front steel brake lines from the brake line block? I have new...
I am still working on my dual master cylinder swap. I am trying to set a record for taking the most amount of time to get it done.:roll: I've...
I've never tried adjusting the toe in on my Jeep before, in fact on anything. I know I have to loosen the bolts on both ends of the tie rod, is...
I'm ready to swap Herm's bracket onto the frame but can't figure out where the bracket goes. Am I supposed to guess where in the frame rail it...
I've been given a new Warrier diamond plate dash for free.:) The paperwork says it's for a '76 to '86 CJ. Think it will fit my '61?
My :hurrican: doesn't want to start. My neighbor who is a auto mechanic by trade says I should move the electric fuel pump which the PO installed...
I did a search and came up with nothing but I remember a thread with a link for an inline adapter to put the temp gauge sending unit in because I...
Driving around today I found a CJ3A for sale. The owner doesn't have a title or know what year it is. It has a L head, plow and runs but blows a...
I have an opportunity to buy a used trans and transfer case cheap. I need to rebuild mine and thought about buying these, rebuilding and taking...
Bought a Pertronix for the Jeep last July. In October it died and got a replacement from Summit with no problem. Last week it died again. I didn't...
I just got a emergency brake handle. Where does it mount underneath the dash? There are plenty of holes that it could mount to on mine. Any...
If my Jeep sits overnight when I go to move it the brakes are locked. No my foot is not on the brake pedal. The first time it happened I thought...
Separate names with a comma.