Go here and download your FSM. There are a bunch of freebies that you should check out. Why not it's free https://oljeep.com/edge_parts_man.html
Appears to be a nice Tux MrkIII. GLWS
Thanks all. I appreciate it. I think I'm going to go WD-40 and plastic baggie.
All my early Jeeps the VIN tag had screws. I'm guessing 65 based upon what I have been around. I believe the 200xxx was 65-66. Someone will post a...
I picked up the internals for a t15. Likely going to be a couple months before I get to removing and inspecting my T15 assy. What would one use to...
1975 and earlier will fit a 67. 55-75 are the same dimensions. Actually a lot of people to include myself prefer the later frame as the glass is...
How about a drive to Corpus area? https://corpuschristi.craigslist.org/pts/d/aransas-pass-jeep-cj-windshield-frame/7597098412.html
Would you care to share where this is located? Have you tried 820 Jeep Parts s up here in Fort Worth area? There is also a guy in Forney, TX...
Not mine and not a Tanktop but a nice Acme- OKC. Thought I'd share if you are close by. I'm scouring every couple days for parts, if I come across...
From a previous owner (its been a long time) but make sure you get latches and hinges and if I remember right there is a top piece. Another tidbit...
I have a couple longblock 360's (1984), and a shortblock with most if not all the fixings if you are not too far east. I am in DFW area. I am done...
So, I am having my 360 block prepped and am starting to pull out spare parts and get them ready. All my .030 over pistons look like this. I guess...
Thought I'd share what I found for 225 and AMC engines. I am slowly buying stuff for my project and came across this. I like their complete...
Want to sell your lights? lol
Thanks for the clarification. I guess I need to look to see how butchered my wiring harness is for the back tail lights. I absolutely hate those...
So, I have a late '75 CJ5. I am finally getting around to working on it. It is far from original. So, unless I'm wrong, an intermediate "Jeep"...
Thanks everyone. I am going to be patient and get to the CJ5 when my other project clears my garage space.
Just for my knowledge in case I do have to go that route what is considered a gen 3 AMC?
Well my 304 is an unknown. The PO rewired the Jeep. He says a cylinder lost compression and it has been sitting in a garage for over 4 years....
Thanks Tim. I really just want to get it running and driving. TBH the cheapest way utilizing the existing drivetrain. So a 304 or whatever you...
Separate names with a comma.