Last year I built a rear seat with removable cushions for my cj5 that doubles as a jerry can holder . It mounts under two tabs mid way of the bed...
Today I picked up some stuff to rig up a kayak I won last year . Well the more I looked at it the more I think about putting it on the jeep . I...
Was there ever a fiberglass hard top for Ecj5 ? Nick has run across a jeep the supposed to be an early 5 with a fiberglass hard top with doors ....
Welp started on phase 2 of old schools build , Pulled out the D 27 after wheeling it hard on our testing grounds yesterday one last time . Im...
Ok heres a report on the install with pics . The distributor is a direct drop in for the stock unit. I just removed the stock distributor (more...
I ran out of time but I think I have a problem . I fired the jeep up to see what it would do , the motor kinda fluttered like it was getting a...
The 67-71 CJ5 had a dual res frame mounted MC , will it swap out in a earlier pre 66 model ? If not I guess Im going to call herm ......... I...
So I started on a easy project , it would have been easier if I had more then scrap steel R) . I had to weld a couple pieces together .Id figure...
Ok my dana 18 has been getting worst since my windrock incident ,getting louder and leaking more :roll: R) . The front yoke has gotten a little...
I drew this bumper out almost a year ago , then I did it in sketch up about 6 months ago. Heres the drawings (followed by the progress) [IMG]...
I Have a friend thats looking at buying a scout for the dana 44 one piece rear axle and the dana 44 front axle. Im pretty sure he is going to have...
Re: Trailer dimensions I dont want to start a new thread because I have a project and a couple of questions. Im wondering the floor pan size and...
Ive been planning a towbar build for a while , I had it all drawn out with 2" tubing with some niffty features added in. So this evening I get off...
Last night around 9 oclock I was putting up a attenna on the back of the house. When I finished I noticed the therm was reading 12*F so I was...
On shannons 75 the rear brake had locked up. I took the rear passenger side drum off and took a look. Every thing on the bottom of the brake...
Im looking for any ECJ5 measurements on a stock jeep , any of them. Frame dimensions , angles ,body , drive train any thing . Im going to try to...
Ive Been drawing out this bumper for a while but now Im able to see it since I did it with the sketch it program. Its not Exactly right but its...
I have every thing to mount a snow plow except for the plow Blade itself. Ive been looking for something sheep but no luck. So got to wondering...
Ok just a couple quick questions . What size square tubing is yalls tire carrier made of? What is the width of the top of your rear bumper? Im...
My home made broach works good ,the thread on it is gone now but its just a modified piece of 3/8th's key stock Test [IMG]
Separate names with a comma.