The last link had all the pictures I had collected and a bunch more, very cool set. I have always thought the tcase would be the hardest part,...
I will try to dig up some pictures I have of tandem axle flat fenders. The .gov played with the idea back in the day and I have pictures from...
My ignition switch failed in such a way that it would make and break ignition power while I was driving. Might check that if it seems like it...
I wanted a restomod sleeper for the Jeepster, to that end the body is stock and the interior is stock except for the seats... Only outside...
I feel for you, I just did this same thing for my C101 last summer. I took a Ford HP44 and cut it down from 65" to 53" to keep my 33/10.50 tires...
I just drove my Jeepster for the first time this weekend with the 5.3 in it. It was a lot of fun till I ripped the teeth off the 44 year old ring...
I picked up the HF one 5-6 years ago, it read fine for non machinist uses, but I found my old Starret dial to be my favorite so when I did use the...
I put the 10" 5100s on my Heep (haven't driven yet, started the engine for the first time last Sunday). I have a front 44 narrowed to 52",...
I like the in tank for low noise and reliability. I have had to be change external ones, and want the factory reliability of a pump that GM spent...
Hey all, I have been working on a fuel pump/tank solution for my 5.3 powered 68. I have gone through several ideas in the last 6 months or so,...
Good to see an update, I hate front end wobble, seems like once it shows up you fight it a long time or are worried about it constantly even if...
If you really want to keep the ross system with the SPO, I think you may want to look into building a high steer arm for the passengers side....
Yes, I notched the mounting plate to fit around the steering box. I don't have any good pictures of it though and the Jeep is with a new owner...
A KOING M100 will fit with a standard saginaw box, tight but it works fine. I believe my PTO adapter was for the wagons and trucks, not the CJ....
This is the easy way, if you look at the part numbers for all the dual tank american trucks, they used the same valve, see above. I used this...
Arm chair web wheeling here, but I would build a new tounge out of 2x4 1/8 or 3/16 box tube, and cut a hole through the front crossmember you...
Thanks, I am looking for about 3" of lift, and a wider than stock spring for my 68, might have to look at the waggies a little more.
Looks good, how much lift are you expecting from the waggy springs?
Man that brings back memories of wheeling around Moscow Id while I was getting my ME degree.... Thanks for the pictures, snow is my favorite...
I had thrush turbos on my fenderwell headers and running a couple of feet of pipe out the back made all the difference in the world (1.75 pipe,...
Separate names with a comma.