I'm looking to find what vehicle my rear 44 came out of. Date code 2C3 I believe to be March '72 or '82 BOM 603400-4 I checked Dodge, Scout,...
I did the normal inspection and found 1 bolt worked its way out of the trans mount and was sitting on the crossmember, the other 2 were loose. The...
Ordered the top bearing, and would need to have the bottom bushing made. I haven't open the column yet and was wonder if the above parts would...
After installing my damper it seemed to me that it should slide in about a 1/8" more. I left the woodruff key were it was after removing the...
I have a NOS (2004) timing cover purchase for I believe a 68 wagon with a Buick 350. It's my understanding I can use it for my 225. However,...
Delco distributor breaker plate # 3 h29 under that # 1110322 No number on the distributor Do the weights need to come off or just the breaker...
I'm in the process of installing a new windshield on my 74. The parts catalog calls for a 2 piece gasket set, (windshield gasket and filler...
In 1968 spring packs were offered in the front from 7 leafs to 12, and the rear from 5 to 13 depending on the order. That being said how would the...
Offroad use only. Would a lower geared t-case (4.1) take on an extra load if the axle is geared high (4.10)? The reason I ask, a friend...
Some will find this useful (points distributors) others interesting but not useful (electronic distributors). The first step is to move your...
Most have heard of using a match book cover to set point gap. Last weekend I was wheeling a friend’s flattie in NH and it was running horrible....
Inline 6 T-5 I’m swapping out the T-5 for a T-18 and found a ball bearing inside the cavity where the input shafts goes. I never saw one in any...
From my understanding the T-18 has two main shaft designs. Some shafts have a hub as part of the shaft and the other has a snap ring and thrust...
I have the slider gear needed from the early Bronco Case (18-8-37) and the 1 ¼” center shaft D-18. The D-20 is currently mated to a Jeep/GM T400....
Going up a steep hill yesterday when the left front tire jumped a large tree root. [IMG] [IMG] I was planning to upgrade but life gets...
I’m ready to button up my front wagon 44 and would appreciate some thoughts on whether to use a disc backing plate or go without. The Jeep will be...
I started this project last June and over the weekend I installed the engine (360), tranny (T-18 ), and 3.15 t-case (20). For axles I have an 86...
I bought a 47 2a a few months ago that had a known leak from the front of the tranny. My thinking was a front bearing seal and possibly a bad...
While I had the t-case apart installing the 3.15 gearing I decided to twin stick as well. The FSJ Pickups, Cherokees, and Wagons have a u-shape...
Found this article and thought it best to pass it along. http://www.brewracingframes.com/id75.htm
Separate names with a comma.