For the past couple weeks I have been busting my knuckles on my TJ. To start with I truly love the North Country, but the salt on the roads has me...
I am looking for the right clutch fork boot for my CJ. It's in the bell housing from '70, in front of a T14. Just need source of supply. Thanks!...
I have Herms dual master cylinder conversion on my CJ. I am having problems with the push-rod. Initially the travel of the push-rod would jam in...
......or just adding to the stable? I'm just in the the process of closing the deal on a '05 TJ Rubicon. I'm not going to quit using my CJ or DJ,...
Just want to add source of supply for old school fender flares, these do not have cutout for side marker lamp. The company is a supplier to many...
I have a couple of pesky cracks in my frame. they originate from the front spring perch on the outside and terminate just short of the inside edge...
Just wondering if anyone has manual windshield wipers. I don't usually run in the rain, and if I do, it is on a trail not the street. I have been...
I see where the 225 OF has a cam button with spring. Does the 231 OF use the same thing? Looked on Rock Auto and I can't find it ( 231 OF was...
If I didn't have bad luck I would not have any luck at all! I finished my Jeep earlier this summer and have been using it when I can, put a couple...
I was just wondering. Would it be a waste of money to balance my engine? It was already rebuilt, but besides the 231 OF:v6: shortblock everything...
Will a 1977 231 odd fire short block replace my 1969 225 short block. I will be swapping over all the 225 heads, intake etc... Just asking the...
I have the throttle linkage off a 1969 CJ that went to the V6. I swapped the stock cast iron manifold and 2bbl holley to an edelbrock intake and a...
I've been working on this jeep off and on (mainly off) for the last few years. I am getting close (with the help of my son). I must admit it is...
Just a couple of quick questions. My rubber glass seal for the windshield glass is two parts, the seal and a spline. When does the spline get...
It's not what I wanted but my Jeep disease forced me to. It's just missing the lunette, and the 2" coupler was done so it's easily reversible. I...
I want to set my '64 CJ up with a stock heater delete, besides the firewall plate what was there? Also where can I find a stock firewall plate?
Looking for a source of supply for the flanged head bolts for the hood hinge's. I don't want to use standard cap screws, but I might have to.
As expected, my pulleys don't line up, p/s pump to crankshaft. I have a Saginaw pump and a single groove pressed on pulley. The bracket is a Buick...
I was working on the Jeep today, doing some powersteering pump mount re-configuring and I needed to pop out the distributor to do that and it...
I have a Holley 390 with a exhaust acuated choke, the carb came off a 1958-64 Rambler W/250-327 engine. I want to change it to an electric choke....
Separate names with a comma.