Can anyone recommend a source for a service manual for my 1962 CJ5? I'm looking for the Willys / Kaiser manual, not one of the generic ones. I...
I finally found a shop to repair my Carter Carburetor. The throttle shaft was quite sloppy with the result that it idled poorly and was prone to...
Termin8ed. I thought you said that you re-did the clutch so I was surprised it was acting up. It is almost like it is failing to let go when the...
Dan, The Jeep was not run for over ten months. That said, since we put it back together I've put over 300 miles on it... Much of it riding trails...
I have a 1962 CJ5 - I recently installed a replacement transmission and had the bell housing off but did nothing to the clutch except hook it back...
My Jeep is almost back together. It has a Solex carb on it (new a year ago) and when you advance the throttle it hesitates just a bit before...
I experimented around a bit today and figured it out. I found a pix on the web with the colors labeled but I think the guy who made it up is...
Thanks for the info. I just got back from a 4 day road trip that took me to Baltimore. Once I have a chance to look over the info and sort...
Can anyone refer me to a wiring diagram for a Spartan model SCS -3R column mounted turn signal unit? I have one that was in working condition...
Has anyone installed a 6 Volt Jeep horn on a 12 volt system? If you have, did you put a resistor in series with it, or? Thanks! Tim
Ok.... time to ask for help. I'm going to replace my mechanical fuel pump with a dual action AC 9526 so I'll have more reliable vacuum to operate...
There is no PCV valve installed on my 1962 CJ5. Can someone tell me how/where they were installed and maybe provide a pix? Thanks! Tim
I have a 62 CJ5. The throttle shaft is worn on the Carter carb with the result that it idles poorly and stalls. Can anyone recommend a place...
I went to the pertronix site and am confused over which "Ignitor" model to go with. The specific application seems to depend upon the distributor...
In september I replaced my carb with a Solex for pretty much the same reasons. I also installed a fuel pressure regulator and set it at 2 psi. I...
"Does your distributor shaft have a lot of play? Up & down or side to side? ". I checked it out and the shaft itself was solid although the cam...
I replaced the points with an Echlin CS725A from NAPA. Fortunately I was able to fish out all the pieces of sheared rivets. Now the Jeep starts...
Now that I have your attention, it isn't as bad as the title sounds. The other day my wife and I decided to take one more Jeep ride before the...
Thanks all.... I pulled a spark plug out today and it was pretty sooty - I don't know whether it's from the original or Solex carb so I'm going...
The M38A1 used 7.00-16 NDCC (non-directional cross-country) tires on a 16 x 4.5 rim. If you are just going for the military "look" there is no...
Separate names with a comma.