Im thinking of selling my hardtop. It fits 76-86 cj5 it is in very good shape built about 6yrs ago. I paid close to $2000 for it. What would I ask...
Hi, As to the brake line just get a new one the same size and install it and bleed out the brakes like you would on any other vehicle. I would...
Thank you, thank you everyone for all of your help. The problem is solved. It was sort of a combination of two things. for one, the MC pushrod...
So far I have: Adjusted the rear brake shoes out until the wheels just barely spin. I also re-bled the MC. Same results. Next up, re-adjust...
My brother who has done this conversion on an oldMustang and old camaro thinks the problem is one of several things: A) MC pushrod is too...
Mine has the bolt in the cap. My setup looks just like these 2 pictures. I hope I loaded the pictures correctly....
OK. The advice I am getting from various people is that the piston in this MC just isnt big enough to push all the fluid needed for the huge...
I think next I'm going to try the re-bleed the MC on the frame procedure, with disconnecting the lines and running the tubes up to the reservoirs....
What are the chances my new MC is not big enough for the larger caliper pistons up front? The MC is a 67-71 dual chamber frame mount MC. It is the...
Oh, by the way- When they say mount the rear brake line system to the front chamber and mount the front brake line system to the rear chamber,...
I did bench bleed. The MC sat for a little while before I got it up in there and connected.I didnt have any plugs to put in. I bled all 4 wheels...
No, the bleeders are definately facing up. I double checked to make sure the L was on the left and the R was on the right. I will double check...
I have got the disk conversion and dual MC conversion on my 68 w/ dana 27 essentially complete. However I have bled the brakes, tightened...
I found 85w-140 oil at autozone. I used that. I got one side of the disc conv done. seems to be OK. I had to buy a 5/8 fine thread "jam" nut and...
Thanks nickmil youve been a big help. I think ill go with the new bolts. If the old bolts didnt tear out in 40 years I dont think they will now....
When mounting the backing plate the conversion article mentions putting in 1/4 inch longer bolts. Why? The original bolts seem to go in fine. If I...
Hi, Finally getting into this conversion after gathering parts for a year. Anyway, several questions: 1) I have it down to the bare...
A D30 (With disc) and a D27 with disc conversion are probably very similar in braking action/ master cylinder requirements??...
Dont need one huh? Could it be that with the master cylinder setup you are using and the res pressure valves, that the ratio front to back is good...
Hi, I didnt see what options were available in the tech writeup for a proportioning valve when doing a disc convert on the front D 27 axle....
Separate names with a comma.