I don't see that it should change the steering direction. The gear box will still turn the spindle in the same direction which should move the...
I am rebuilding a '46 CJ2A. I am putting a Dauntless V6 in it. I want to keep the stock Ross steering setup but the end of the drag link hits the...
Yes, the larger plug goes at the front but does it matter which end of the drag link rod the plug goes in to; or, will the large plug only work at...
Does it matter which end is front and which is back? Doesn't look like there is any difference in the shaft bends and Service Manual says no...
Mortten - is the drag link still available?
It may just be the picture but the fan looks like it is low on the rad. Is this normal ? Will it cool properly in that location?
Moortten, yes I am interested in the modified drag link. Where are you, how can I contact you ?
I am rebuilding a '46 CJ2A. I was going to put Dauntless V6 in it. I have V6 motor mounts welded in frame. I thought I read somewhere that I...
Thanks for the picture. That helps. Does the front left have the same frame bracket? Do you have picture of left front?
Does anyone have picture to show how/where the flexible rubber front brake hoses (right and left) attach to the frame? I think my frame must be...
What lube should i use in the Ross steering box of 66 Cj5? There is fill "plug" on the box that makes me think something that pours e.g...
I had the same problem finding springs for my 66 CJ. If yours are the 10" drum brakes, try trailer brake parts. That's what I did. Trailer 10"...
I'm looking for good rebuild guide for the Ross Box steeering in a 66 CJ5 with V6 engine. Also, what gear lub should I use in the steering box?...
I'm reassembling the front end. Are the tie rods supposed to be level or angled up to the bellcrank? Mine are about 3.5" higher in the centre...
They are self adjusting brakes but I was thinking of not replacing the adjuster lever and linkage. On which side should the LH & RH threaded...
For 66 CJ5 the adjusters are left-hand thread and right-hand thread. Do the LH thread go on the left side (passenger) and the RH on the right...
Sorry, I don't have an answer to your question but you might be able to answer a question I have. I am redoing my brakes (66CJ5 - 10" brakes)....
I am reassembling 66 CJ5 10" drum brakes. Two adjuster barrels are right-hand thread and two are left hand thread. Which ones go on which...
I've removed the entire drive train from my 66CJ5, 225 V6. I am now reinstalling the entire drive train (axles, trans/TC, motor). Everything...
Thanks. Anything in particular I should look out for? What gets swapped out and what gets swapped in?
Separate names with a comma.