Into a 73 with minimal headaches?
And completely different from most of the builds but I thought Id share anyhow. Its a 99TJ with a tbi350 with a couple goodies in it, 700r4 trans...
Make sure they are worth a sh*t before you trust your vehicle on them...Luckily I was beside it and not underneath it.. [IMG] [IMG]
What are they for? The symbols are worn off in my 72 bullnose, and the only one that works is the headlights. Im assuming the rest are...
Well heres the new ride if you havnt seen the pics yet... [IMG] So I swung by Franks today and welded the spiders for the 14bolt so I...
Hopefully I can get an idea...How much space does one have in the front seat area compared to say a CJ7?
Anyone know what the stock flattie sending unit ohms at when full and empty?
Alright I need some swapping info. Got a T86 from behind a :v6: that is junk, all the gears are rusted and some are chipped. Also have a good...
So the rear yoke on my tcase will not quit leaking. Ive tried the felt seals, a newer style felt less seal, permatex on the splines.. and it will...
Been searching and reading all over the intraweb and I still have a couple questions. Is necking the coolant lines down to 1" ID to much of a...
Not sure if this has been posted here on the site before, but we just found an EASY way to swap in a Wag. Dana 44 with the 6 lug under the front...
The time has come for a build up thread.. But before a build can start ya gotta have a tear down...So that began tonight heres a pic. More...
So can you swap a d18 gear set with the 6 spline bull gear into a d20 case behind a T18?? If you do can you still get the 2wd f/r hi/lo options??
What size tires you running? Do they rub? Stock yj springs or something else? Do they have more up or down travel or are they about even?...
Has anyone weighed a 2a to get the front/rear weight while its sitting?
The axle I took apart today to rob a front axle shaft out of today had one spindle nut then it had another nut that spun and that had 3 set screws...
Can they be used in one another?? From searching it seems they are the same size..so will they interchange?
From this thread http://www.earlycj5.com/forums/showthread.php?t=37443 The shaft that sticks out beside the rear PTO?? [IMG]
Anyone ever added on to the factory skid to protect the ebrake assembly or the gap in between the oil pan/tranny plate?? It just seems like...
What has everyone come up with for putting rocker guards on a flattie? I like the idea of some angle bolted to the tub with some 3/4 round welded...
Separate names with a comma.