Just remember that with the electric pump the fuel keeps coming even when the engine is not running. A friend of mine burned up his car with an...
Some heat warpage may happen but the above recommendations will lessen it. Also, I agree that bodo is not bad. Heck, new cars have bondo in...
Ditto for me everything "Double R" said above - exactly what I did too.
Here is a before and after. Be sure to take all old bondo out. This hole in mine had been covered by about a gallon of bondo!
When I did my body work, inmost cases I cut the new metal to fit as closely inside the hole as possible with about 1/8 inch clearance all around....
I redid all of my brake lines with simple hand bending tool. You need to be careful to not pinch the tube if you bend it without a proper tool -...
As I recall NAPA could get one type of Jeep cylinder and I needed the other type. Mine, like yours, is type with the rubber brake line coming...
On my "Sure-Grip" Dodge Challenger I recall getting both wheels off the ground, spinnning the wheels (both spin of course) and just counting the...
I had lots of problems with a VW Beetle's brakes once and the culprit ended up being the rubber brake lines. They were clogged-up. Could be one...
If you look around you can find an original style replacement. Look on ebay or this forum's For Sale area, etc. I purchased two originals from...
Since the system is free of air (at least I think it is free of air ...the bleeding of the brakes) I would think the lines (and the whole system)...
Ground the sparton with its own ground wire. It made my sparton light work. All I have is my experience and it worked for me. When it comes...
One other word on this. I think that actually the valve is supposed to mount on the firewall. My valve was missing the 90 degree flat piece on...
See this thread. There was a heater valve stock for some CJ5s. Mine came with the valve in a box or parts. The PO had removed it and installed...
Here's a pic of the control knobs I mentioned earlier and of my heater box and the fan motor before I installed them. My air box (a '63...
Pre 65 or 66 models (not sure the break point) do not have any vacuum controls - its all manual. Mine has three push/pull knobs (like manual...
Looks like there has been some serious weight in there. I don't think there is much to be done except replacing the floor or putting something...
Drum brakes are infamous for sticking when left sitting, especially if in the open with moisture. I have lots of old cars sitting around and am...
When you say "crossmembers", do you men the reinforcing crossmembers that are spot-welded to the underside of the floor? Which way is it bowed, up...
I don't have the specific info you need but I do know that some odd things go on with respect to parts and their interchangability. They could be...
Separate names with a comma.