The 225 is not related to the nailhead in any way except the fact that they are both Buicks. The nailhead converted to a V-6 would have been a...
Two things to consider.. if you have a different linkage cam the radius of the arm pivot might be smaller or in backwards, i've seen that arm have...
Check your linkage for slop and wear, and watch the clutch arm and see how much it moves when someone else presses the clutch pedal.
There are many factors to consider when deciding on a tire. Mud? Rocks? Sand? Dirt? Pavement? Snow? How much clearance do you need/have? How fast...
It should handle that combo easily. Weak spot is right on the bottom where the bottom hole gets near the whole straght behind the tranny. There...
Well take me out behind the barn and shoot me!! LOL I just looked at the picture again and there is a very obvious piece of 'not jeep' installed...
Some of the 1970 CJ's had the tapered axles since they were just re-badged 69's. My father has one of these.
Yes that is a D18 transfercase. However, unless the engine/tranny is all moved forward quite a bit I cant see that being a TH400, maybe a TH350. I...
This is what I did on my 67.. I am close to 300 lbs and if I bounce up and down on seat it doesnt budge, means it should be strong enough for the...
I believe it was the early 60's when all of the manufacturers stopped using left handed threads, not 100% sure, but my brothers 64 Chrysler had...
My 67 V-6 CJ-5 came with 16"ers from the factory. Still have the wheels too, all 5 of them.
I've always understood that a higher stall speed let the engine rev higher before the converter "locked" up, so with a 300 stall you would have to...
In a lot of places the little CJ will out do your XJ, mostly because of the size. Many more options when it comes to lines over the obstacles and...
I've been around the 2GC caarb all my life and have never had problems with vibration causing it to spit and sputter. I've had them wear out and...
I put a 300 Buick V-8 in my CJ-5... only thing I had to do was push the radiator up against the grille and bolt it in, but the 215 does use a...
AMC bought Jeep in Feb 1970.... so late manufactured 70's are AMC, didnt make any changes to the 70 mid-production year, but did for 71. All 71's...
I found a 79 CJ in the boneyard, took the brackets, went to napa bought new calipers and brake lines and to a brake parts place and bought brand...
Another factor.. I've seen people run a 427 Chebbie with the stock small shaft D44 and D27 and never break.... its called driving style. I have...
My 67 used to have the wood spacers and since the original owner never had it apart I know it is factory with the wood spacers. My fathers 70 had...
I'm going to be building my own fenders too. i'm gonna buy a conduit bender from Home Depot, buy some 1/2" or 3/4" mild steel tubing, some...
Separate names with a comma.