Sorry for the use of the p word. Mine are always in a project state... I've got a 72 cb500 thats my regular bike I've driven for 4 years that I...
Thats a pretty sweet find there, enjoy your new project.
Thanks for the info, this should take care of me.
The reducer makes sense, any idea where I can find one of those? I don't see anything on Walck's of Kaiser Willys site. That's what I thought on...
I've got a 62 CJ6 with a F134 that has sat in my garage for 3 years being slowly worked on... Hoping in the next month or so get it running again...
Ok, so I am nearing the point of starting my jeep for the first time in 3 years of slow work and am hooking up the heater while I am at it. I...
Looking great! Keep up the good work.
Yeah, that could definitely be neat. I've got a 6 that the sheet metal is in very lousy shape. I'm thinking of doing a pickup/ute type of setup....
I definitely like the blue. Looks like beautiful land you have around there as well.
Most aftermarket ford rims have the larger hub and will swap to both. I can specifically account to the 1980-96 which are very common in junk...
The only thing you have to watch out is hub size. Many other vehicles have the same bolt pattern, but smaller hub sizes. For example wheels off...
If I've got a nut that an impact won't touch I put a 1.5" steel pipe that's about 12' long and an 8 pound short handled sledge. Slide the pipe...
No, I definitely got it out, it was only the outer section left when I started. It's down to the curled section of the spring for sure. I was...
I was replacing the Shackle and bushings on my rear springs on one side earlier tonight and ran into a problem that I couldn't get the new bushing...
Ok, so it's not the grease itself that is the problem, they just shouldn't be packed. I'll lightly lube them with some white lithium. I'll also...
Ok, Thanks.
Would gear oil work to lubricate them after cleaned?
So I recently acquired some warn locking hubs from an axle I got from another forum member here. The axle itself was shot (didn't need that) but...
I had tired it a couple times before on motorcycle parts and a gas tank. Never was impressed with the results. Ended up having to use physical...
That photo is perfect! Mine goes into a tee as well but the originals were shot. That should give me the spacing I need. Thanks a lot
Separate names with a comma.