It's been a long time since I posted anything about the LJ so I thought this might be a good project to write up. I have wanted to add hydro...
Not a quiter yet, but I am looking at a '06 LJ Rubicon tomorrow.
My wife has been complaining about needing a step to help her get into the Jeep. She's only 5'1" and I must confess it's not getting any easier...
I have decided to either make or buy a crank trigger setup for my fuel injection system. The erratic (oddfire) tach signal that is being sent to...
So, after wearing out the intermediate shaft on my new TeraLow t-case in less than 1000 miles, I decided to do the AA tapered bearing conversion....
With a little inspiration from johneyboy03 I started a new project. I sent my Saginaw box off to Redneck Ram in Texas for a rebuild and porting...
Just wondering if anyone has converted or tried to convert an oddfire engine to run a serpentine belt.
OK, I know this isn't a "Jeep" trailer. But it's still pretty cool. I recently took possession of a work trailer from the Rubicon Trail Foundation...
Can a small hole t-case front output and shifter mechanism be used to convert a large hole D18 to twin stick? I have a small hole t-case that is...
Is it true that a D18 with the 1 1/8" intermediate shaft is always a small hole t-case, or is there some overlap with hole size and intermediate...
I read somewhere that you can r&r the intermediate shaft in a D18 t-case without pulling the case out. Just wondering if anyone here has done that...
I've been working on a volunteer project for the Rubicon, making marker signs for the waterbars that are on the trail. Just finished the 1st 24...
Yesterday our club did a run up to Watson Peak for a scenic lunch overlooking Tahoe. Almost to the top of the trial I noticed my fan was tapping...
Bought a new Bestop Super Top for my Jeep. Got an issue I hope someone else had figured out already. The three bolts on each side of the tub that...
[IMG]
Last November I posted up a WTB for an offset D44. I didn't really expect to find one close by, but figured I look anyway. Mike Starkey pm'd me...
Anybody out there care to share how they routed the cable to a rear Ox locker. I'm searching for a good place to mount the shifter and path for...
It's been a long time since I worked on a tapered D44 axle. Is there a hole in the flange that allows you to get to the backing plate bolts so you...
Anyone out there ever replaced a broken shift fork on a Saturn overdrive? I have the housing pulled off the back of the t-case. Just not sure...
This install went really well after I bought a diff. case spreader on eBay. I've been told you can install an ARB without one, but that didn't...
Separate names with a comma.