The cross shaft is clutch sensitive. Like Oldtime said, there are two shafts and they are different. The difference being the "clocking" of the...
I bought some gl4 a while back and used it. GL4 isn't available at FLAPS. GL4/5 is available, but it is the qualities of the "5" part that can...
I bought a brand spanking new set of aftermarket seats from one of the Jeep vendors. I installed them and almost immediately "uninstalled" them....
I can't speak for all clutch tubes, but I can speak for the 8.5 inch vs 9 inch F-134 clutch tubes. If you can examine several clutch tubes for...
There is a right way and a not-so-right way to install the cutoff switch. The right way is to put the switch on the "-" ground side, as close to...
At that time the t98 and t18 ( early model t-18's with reverse over and up) were almost identical in terms of main housings and components. So,...
I used to live in Chesapeake Va when I was in the Navy ( CT1) at the NavComsta Northwest down on the border between Va and NC. I rented a duplex...
I have WAY too much time on my hands... I track the miles driven on all my automobiles, and hours on my tractor and generator(s). So,...
These kinds of troubles can originate in the turn signal. Normally turn signals don't go bad, they just get dirty or someone connects them wrong....
I had a brand new oil sender that I put in a freshly rebuilt engine and a couple of months later the oil light came on intermittantly. Put in a...
My hose from the air cleaner to carb finally gave up the ghost. Since replacement hoses are of such poor quality I'm going to replace the cleaner...
O'reilly Auto Parts Mr. Gasket pump 42S
Anyone have a part number for an electric fuel pump that'll work on a F-134 with the stock YF carb? PSI of output??? kamel
You have a simple choice.... replace it now when it is easy to do, or replace it later when it is going to be several orders of magnitude more...
1 and 4 ???? 1 and 4?? That is suspicious... So, the straightforward and simple question that I'd have to ask is "have the spark plug wires...
This topic has been covered about once a quarter for years. You can fool around with pressure regulators, expensive filters, and multiple...
A much ignored spec on jeep wiring is the shape of the harness. I always use 'experienced' harnesses rather than new. I've built my own in the...
Turner 4 wheel drive 1-800-the-jeep They've got 'em --
I've swapped in a flanged axle before. You will need the following parts: Complete dana 44 flanged axle assembly from a 70.5-71 CJ 2 inch U...
Are you sure that the sector shaft is bad, or perhaps you only need the bushings to keep it from leaking? Bear in mind that a "repro" sector...
Separate names with a comma.