Before I start pounding out bushings, if I understand correctly, these bushings are backwards arent they? The long ends, to the right on the...
Just an update, Benz Spring is still churning out these springs. Just got a set delivered. Plan ahead, took about 9 months. Benz Spring is a...
New EFI Option - Looks Like 3 Good Players Now Lots of infor from me and others in the above link. Ironic that I went from 2bl to 4bl intake...
Relatively simple. The magnet is in the pickup so it just triggers off steel. The plate the pickup is mounted on sits on top of the fuel pump...
I can post pictures tomorrow afternoon and no to the trigger wheel question. My understanding is a trigger wheel is for a crank position sensor...
I picked up a Holley part 554-124 Crank Sensor HE. Its not the cheapest sensor out there by any means but I dont have junkyards available to pick...
The video you have of the snap on meter with the idle bouncing between 600-900 RPM, that looks a lot like the idle bounce issue (even the range of...
I love that one selling point was that the hubs came in a "dirt-free metal box" (the early 50s testimonial). Was that so they werent confused with...
After weeks of waiting for an oddball M12x1 tap to make the bracket for my magnetic pickup I fired the jeep up a couple days ago. It then took me...
pfmg, what size are the tires on your jeep?
I thought about just leaving it running the way it is but I think I will lose out on some of the ability and performance of the FI if I do. As I...
No, the engine is running better than with the carb, starts faster. In addition to the uneven pulse from the HEI tach on the oscilloscope I...
Well, I have driven the jeep back and forth down the local road. It runs good but the little display panel the sniper comes with, the RPM jumps...
Well, the Holley 2300 TBI is in. Fired right up. Idles good. I have to tidy up wires and fuel lines before I can take it for a spin. The Holley is...
I have been doing some Holley Sniper research. One complaint I have come across is that the secondary bores open with the primaries. Some people...
Lets see, aluminum 4 barrel intake, manual choke. I have watched the choke, aside from moving the choke plates I only see it moving the cam the...
Has anyone had this Rochester 2 barrel 2G issue, have searched and not found anything. After replacing my 2 barrel cast intake manifold with an...
I am about done collecting parts to put a 30 spline ARB RD116 in a Dana 44 axle. I was talking to G2 today about their 35-2033 Dana 44 install...
I got my TA Performance timing chain cover on after various issues (including using the only 225 gasket stocked in Hawaii and had to mail order a...
I dont understand Warloch's comment above, about a 231 timing mark being 18 d off. I came across a Buick page listing 5 BTDC oddfire and 15 BTDC...
Separate names with a comma.