I've been having problems with starting when the engine is hot. It happened again just now, I make a quick stop at a store, maybe 5-10 minutes,...
Can the mirrors in this kit go on either side? or are they side specific? [img] I'm trying to install a mirror on the passenger side and I...
I built an air tank but used one of the worst possible cross section; 2"x6"x1/8" of tube steel. Main reason for selecting that shape was that I...
I've converted to swinging pedals and been using a YJ clutch master cylinder. My slave cylinder came from a kit I bought from Novak, which is...
The person who installed my windshield glass put black caulk on the edge of the rubber seal. He laid a bead of sealant/caulk where the rubber...
It was never connected to anything. IIRC, it was on the floor by the driver's side. [IMG]
Anyone have a picture of the liftgate latch? They are missing on mine and would like to see how they attach to the mechanism. Is it just some...
I finally got to test-wire the rear lights and brake switch yesterday. It took the whole day to get the brake lights and turn signals to properly...
Where is the typical mounting for these cable operated winch contactor/switch? how are the cables routed from the cab to the engine compartment?...
After searching the internet, I found out that I have the American Bosch WWF wiper motor that is upper mounted. First off, are these motors...
I want to get started fixing the sheet metal on my windshield and need to cut new panels out of 18 gauge sheet metal to be welded on the bent...
I have a Chevy 4.3 and I'm using a stock radiator that has been re-cored. The radiator outlet and the water pump inlet are not the same size....
I have 3/4 ton full width axles (69" wms front, 67" wms rear) and would like to narrow the track width a little. I would like to recenter my rims...
Make your angle grinders ergonomic so I can go 8 hours of straight wire wheeling without having to take a break to rest my hands.
Hello, This is my CJ-6 project which I started in 2001. I bought the jeep for $500. It was an empty shell when I first saw it. It had no...
I've removed the differential on a dana 35...all that is left is the pinion gear, rear bearing cup and the rear bearing still in the pumpkin...the...
...
how long can you not run a motor and still be able to start it cleanly?...i've had my 4.3 sitting in my project for about 5 years now...i haven't...
I've drilled the holes on the tub for the body mount bolts to go through...my problem is that i drilled the holes on the wrong spots...the tub...
Separate names with a comma.