Thank you all for your help. I got them on a diet and they are not slim enough to fit.
Howdy, It has been quite a while since I have been here, but I really have a question that is holding me up on the build. When rebuilding the...
That was a typo. It is a 1966 CJ5.
I have a windshield frame from a 66 that you are welcome to. I am a noob at this Jeep stuff so if this is not what you are looking for I apologize.
Forgive me, but is that the carb that is on an F-head? If so I will rebuild my carb while I am at it. Thanks!
In my searches I have not really come up with anything that has gauges and lengths. I will continue to look as I have time, but if anyone has a...
Thanks! I have done some searching. I even thought about getting the Kiser/Willys kit for $300, but that seems like a lot of money for a few...
I have been looking for a diagram to re-wire the jeep. It had 50+ years of jerry rigged wire so I pulled it all out. Will this (see the link...
Please just delete it than. Wondering how to correct a SOA problem like that is not hijacking.
Where/what would you get the steering bits for a SOA swap? I am am thinking about doing one.
Yes, I ended up going with the kaiserwillys kit because it was a more complete kit for the same money. I doubt that I will be ready to bolt...
Ordered today! Free shipping. I asked for a discount and was told that the springs were already discounted, but I did get 10% on some LED tail...
Remember there is a head bolt under the carb!
My question is WHY? Good lord that is a lot of spring. If they were not cracked (and how the heck they got cracked is beyond me) I would use...
I counted when I got home today... 12 front 13 rear!
Tom, I just got off of the phone with the guys you were talking about. This may sound dumb, but I am trying to put this thing back as close to...
Thanks for the help guys. Bob only had a 2 1/2 lift kit set for my Jeep. I am not sure that I want to lift the Jeep that much and have small...
Howdy again, I have been doing some searching for shocks and springs. So far this looks to be the best deal (see below). Does anyone know of...
I guess a wire brush it is. The chemicals do not sound to nice to the environment. When I pulled the head the first thing I thought was, "Why...
I pulled the T-stat housing and there was a lot of what looked like copper corrosion. Under the T-stat there is a ton of rust in the cooling...
Separate names with a comma.