I was looking thru a pile of parts I have and came across a nos CJ3A or early 3B drivers side tail light. It is in the original Willys box with...
Does anyone have a source for FC-170 front wheel well mouldings?
I have a 1954 Willys CJ3B with an LS1 style motor and turbo 350 transmission. The front end is a custom built Dana 44 with 4:56 gears and an Eaton...
I have a problem with a GM Turbo 350 transmission I adapted into a older Willys jeep. The transmission is out of a 1973 Chevy Blazer 4 wheel...
I have a Warn Full Floating axle kit for a 75 and prior CJ with Dana 44. The original hubs listed in the manual shows Warn 36655. Does anyone...
I was looking at picking up a used full floating rear axle kit for a 1974 Dana 44 CJ5 axle. The problem is one of the wheel hubs is bent beyond...
I am putting on new leaf springs on my CJ3B , they are 1.75 inches wide. I bought new pivot bolts but the are a little longer than stock. It...
I bought an empty dana 44 housing that I will be putting 4.56 gears into. The inner pinion bearing race was still in place and I removed it an it...
Does anyone know if anyone still makes 15-12 inch wheels for a Jeep CJ, prefer aluminum.
For those that are running Holbrook suspension in their flatties which model number shocks are you running?
Has anyone used 4 inch lift springs on their Cj3B, if so what brand, I have old worn out 3 inch Black Diamond springs on it now.
Does anyone that used Holbrook springs on a flatfender have a copy of the instructions they could provide to me? Thanks Mike
I am trying to find out the diameter of the 2 bolts that hold the caliper to the knuckle on a 1979 cj5 dana 30 front axle. Thanks
I have a CJ3B with a centered dana 44 rear end and a custom dana 44 front end. Spring under with passenger side drop. I am looking at doing a...
Does anyone have a source for camber adjustment shims for a Dana 30/44 that fit between the spindle and the knuckle. I have searched on line and...
Does anyone know if a Warn style overdrive would bolt to the traqnsfercase?
Is there anyone that has been able to make a 181 or 3.0 mercruiser or industrial motor work in a willys. I am concerned with the intake and...
Does anyone know if MD juan makes a replacement tub for a 1971 renegade. This would be without the tailgate in place only a solid read panel....
I am looking at a stock 1973 CJ5 renegade. It has the decals on the side of the hood but there is not black stripe down the center. Is that...
Are the original vin plate screws Phillips or slotted on a 1952 CJ3A
Separate names with a comma.