This may not apply to your newer jeep, but I had the same thing happen to me in an earlier model cj5. The drive gear in the transfer case (i.e....
How much for the pto. I understand that the pto's are DIFFERENT depending on whether the model20 transfer case is Jeep or Bronco. I have a...
It's out of a CJ6 (don't know what engine). It would include the input shaft, but that doesn't do me much good since I don't know what size the...
I have a T18B (i.e. like the T18A but with only the 4:1 1st gear instead of 6:1. It's in a modified Jeepster with the V-6 and mated to a dana 20....
Thanks very much - that engr reference is perfect. - mike n.
No one ever answered this when it was posted couple of years ago. I have the same question. 56 cj5 -- what is the correct torque front spindle...
Will the knuckles for a model 27 front axle interchange with the knuckles on a model 27? thanks, mike n 56 cj5
yes - he basically said that the 3 and 9 o'clock bolts don't have enough room for studs (my 3 o'clock is one of the ones that was stripped). I...
56 cj5. one of the knuckles has 2 holes, ( 3 and 4 o'clock) that are 'almost' stripped. Before I get a new knuckle (or even if I do), would...
It's not a spring. Generally there are two -- each one is a resistor. In the front , one of the relays senses the voltage and --when too high it...
Hi Pete, I also just picked up a 56 - 60 (abandoned on a ranch 30 years ago) cj5 which has keonig front pto winch and rear pto. -- no attachments...
early cj5 - frame vin location? year of cj Hi, I recently acquired an early cj5 that was abandoned on a ranch about 20 years ago. I need to get...
Separate names with a comma.