Thanks...
Billy, I received an interesting email from Beth <jollyjeepers> that contained a form to support a national bone marrow group. When I opened...
Great looking doors! Best backyard fix, I've seen in a while. :) One comment, though...you may want to drill two additional screw holes in...
I have a set of wide tracks on my 1985 cj7. The D30 has a lockrite and 4.10 gears. The AMC20 is open, but has been retro-fitted with one-piece...
Yea, you think?? It's been a long time since I had to worry about timing and dwell. :roll: 'Guess it's time to retro my tools to match my...
NO, not yet. But, have you got one, if I decide to change?
The P.O. of my '85 CJ7 swapped out the electronic ignition for an early '70s distributor. Wear and tear has resulted in my pneumatic spark...
Brad, Thanks for setting up the download. But, I'm having a problem downloading the file. I'll keep trying and (if needed) I'll PM you to...
Well, historically, it has run pretty good. But, flooding on steep inclines has been a continuing issue. I'm thinking that I can use this new...
Nope, it's not electronic, but could have fooled me when I first saw the stream... :shock: Thanks for the info guys. I appreciate the comments.
I tried to crank my 1985 CJ7 last Saturday, but never could get it to run. It acted like it was REALLY flooded. So, I raised the hood and...
You can remove the short leaf(ves) and noticably soften your ride. But, removing too many of your shorter springs will result in dipping,...
When I installed a twin-stick on my 1985 CJ7's DANA-300, the following was the resulting shift actiion: Drivers side stick: Back = high...
The rear end is higher than the front end. But the side section of the body (that contains the side doors opening is continuous. So measure the...
The problem is at the side window. Even if you are handy with fibre-work, I'm not sure there's any place (any one, single location) you can...
I bought my 1985 CJ7 with 31x10.5x15s on 8x15 rims. It didn't have any excessive spring sag, so, everything worked well. The tires tucked...
A word to the wise...if you decide to heat treat the metal, DON"T use water as your rapid cool agent. Water will cause the steel molecules to...
I run 33x12.5x15s I started with a 2" lift shackles. But had to trim the back fender well slightly to clear the back tires under extreme tuck....
Welcome Scott, from South Carolina. I assume that you have checked your timing on the engine. If not, you may want to make sure it's not too...
Can't help on the spring question. sorry... :oops: But, wanted to say welcome from South Carolina, anyway!
Separate names with a comma.