could be laquer too any decent polyurethane clear should be fine.
drill some holes in a plastic cup that will fit down the hole in top of the tank and over the pump? if the pump is sitting on the tank bottom it...
They really pep up an old jeep they rev crazy
If you don’t care about originally try the hardware store for dryer vent.
If it’s glass everything needs it’s own ground but that may not fix the bad wipers.
they will fit in a big flat rate box btdt
worth it just for the flanged rear
No sealer on a gasket urethane ane is for glued in glass no rubber.
I went the other way 232 to 304...easiest swap ever pulled the 232 bolted the 304 right in. in the shop at 7 am driving by 7 pm
bad ignition switch?
his looks way too clean for that though
no idea but out east with the tight rocky trails yup and 35s break other parts. i run a 32 x 9.5 ish tire
just put a 4.3 in the wifes 76 cj7 used an sm465 with a dana 300 . plenty o power. still ended up making new driveshafts. not shorter that way.
not run 35s , definitely not with 3.73 gears
mainers work too i thought vermont was easier my mistake...
get ahold of the dmv in vermont....they seem loose with titles and registrations for out of stateers. could end up with a vaild vermont plate and...
Get real striping paint you will have way better luck. Damhik
iI have one of those it works sweet. i do rims and vintage auto stripes on occasion.
I just bought one from the flaps it was less than ten bucks and was a name brand part.
https://www.boltdepot.com/fastener-information/Bolts/US-Recommended-Torque.aspx#:~:text=US%20Recommended%20Bolt%20Torque%20%20%20%20Size,%20%2064%2...
Separate names with a comma.