Couple of questions/problems I’m having with my new MC. 1. I need to extend the pushrod a little to get full travel. I’ve twisted and pulled but...
Seems like this item is “out of stock” everywhere. I’ll gladly buy a used MC in good condition. This one… [ATTACH] Mine doesn’t look so good....
Trying to order a rebuild kit but they wanted more numbers off the carb. I just don’t see anything else. How to proceed? [img] [img] [img] [img]
Is this '67 supposed to have this many spacers? It looks very tidy, like factory, but it seems excessive. My 66 had none before transmission swap...
Don’t we have a list somewhere here? [img]
I posted some pictures of this Jeep a neighbor had a month or so ago. I’ve been talking to him about it and recently he said to just come take it...
I'm getting a '67 for next to nothing but rust has taken these parts for sure. I hope to get it running driving and stopping then sell it cheap....
So I saw this somewhere and it got me thinking so I googled it. Lower center of gravity and long travel. It’s been done for years on off-road...
I hear that folks replace them? I have 2sets for my jeep (which runs rich) So far I just switch them out. I clean ‘em with a brush and paint...
I bought this project VW a couple years ago. Cynthia had a couple VW busses 10 years ago and now she wants a Yellow Bug. Did some work on the...
Hey now! I bought a NT swaybar from EBay a while back but now need the hardware. The diameter looks to be 15/16”. I see mounts online for 7/8”...
So a neighbor (a few blocks down) I never met before catches me today in the driveway and says "I got this old Jeep". We've all heard that...
Hi. I’m getting into the maintenance of the Jeep for summer wheeling. I took the brakes off and pulled out the axle. In the past I’ve packed...
Trying to figure out how/where to position a new over flow tank for my V6. Is the height in relation to the radiator a major consideration? It...
I got two for Christmas. 1"×30ft Kinetic Energy Rope Truck SUV Tow Rope,Recovery Rope 30000lbs,Towing Rope (Orange) by Best Off-road Store...
Seems I finally got the rear main seal right but still got a small puddle of oil on the floor while running the cam break-in. 1980 Buick 231....
Just one. All the new rings went on the old pistons no problem except piston #1. This one is damaged somehow and the rings don’t spin at all on...
Wanted to Borrow. Doing new rings on my old engine and wanting to avoid another $70 tool that I'll only use once. My 231 has a 3.8" bore (same...
Swapping in a 1980 Buick 231. The brake MC prevents the PS pump from adjusting up enough to get belt tight. I’d never get the cap off either :n:...
I seem to remember that there was a driver and passenger side engine mount. I forgot to make a note when I removed them. Which is which? How do...
Separate names with a comma.