Thanks. I’ll report back as well. my bell housing has the adapter to the transmission. the auto parts place i use ordered it without charge and...
It has the cable linkage. After measuring the new clutch with the bearing stacked on top compared with the old clutch and bearing stacked on...
1970 cj5; v6; T14a; Dana 18 how snug of a fit is the Throwout bearing supposed to be on the clutch fork? I have a new clutch fork from Walcks...
Yep. I was just curious if there was something else that caused the misalignment that I need to avoid. definitely planning on using the...
Thanks. Was just curious if there was something else I needed to look out for
Would you mind sharing what caused the misalignment? I’m replacing mine and would be curious as to how to avoid that.
Here’s the image my manual shows referencing the 1-15/32 [ATTACH]
Just mentioning as another option, oreileys sells the felt type gasket material in rolls so you can cut your own.
Here are the images from mikes carburetors instructions that boopiejones referenced above. [ATTACH]
Here are the instructions in my TSM for setting the float [ATTACH]
135 8356
This is what my 225 timing marks look like.
Thanks.
Thank you. I’ll update my profile and will look for the parts book. Thanks for the suggestion. I appreciate it.
Getting ready to order parts. Plan is to replace everything as you all have suggested. I called debella’s and they do not carry the clutch for...
Found some time to get the clutch removed. Here’s the flywheel [ATTACH] Pilot bearing [ATTACH] Flywheel side of the plate (plate is stamped...
Yeah I want to replace all of it since I’m neck deep in this. Will I need to worry about re-balancing when I reinstall with new clutch and...
I’m getting ready to take this off. Other than marking it so I can put it back in the same orientation as it is now, is there anything I need to...
Agreed but I wouldn’t do that
I did notice that the pivot ball was not sitting in the divot in the arm. It was sitting on the rim of the divot.
Separate names with a comma.