Repacked the rt ft wheel bearing tday after work on the blue 6. I got the lt ft a few days ago so I'm good to go for a while on that one.:clap:
Looks really good
Not all today of course but, after work each day. Tuesday I changed the thermostat in the tan cj5 from 195* to 180*, and it certainly runs cooler....
Thats always the trouble I have with Rustoleum:banghead:, but your jeep is coming together.
congrats:bananatool::beer:
I would check all bottom end bearings, and if this is all you find that is bad, put that one in it and run it. You may destroy some other stuff,...
Your array of tools looks like some of mine.:lol: I can't do anything without getting out every tool I own.
It is and its addictive too
Thanks, I'll get to the PO in a day or two
I'll take the dana 20 shift poppet set
Fuel pump I've got is a Carter M2846. It does have the added vacuum for the wipers. Shows out of stock at Rockauto
I think I got a new one on the shelf that I've had for a few yrs. Bought it for a spare. Don't remember the manf. but I will check if you are...
GREAT
Most of us have a couple rear dump man. laying around. If you don't find it closer to you, then PM me, I would think I'd have one.
Sure
And I did just that. It was made of 3/16 metal, so I upgraded to 1/4
That extra 20in length on a cj6 is good for more than just seating. ;) I built a home made tank that spans the frame rails. I gained 9 gal with it.
Looks really good, but $40K
Found this a few days back under the blue 6 [ATTACH] So tday, I cut it apart [ATTACH] and make the broken part like new [ATTACH] Hope to bolt it...
Looks like a caster shim (wedge) between the frame and hanger bracket. Looks better now
Separate names with a comma.