The bushing can be removed and a new one pressed into it. Once the old bushing has been removed, measure the outside dimensions and the shaft...
Remember the pedal/rod will be kept in/down with the floorboard once the body is back on. No need for the additional spring.
My NAPA makes my hoses. I live in a small town in West Texas.
Battery box cover was deleted in 64". This only opened on the M38A-1's. Was welded shut on all CJ5's.
With a new tank , gas tank sealer would be a good option. I did this on my old tank and worked great. I have always heard "Bill Hirsch tank...
I have the heavy duty one from KW. Works great. Has the special nut that screws on to the column and keep from buggering up the threads and end...
Walck's also has the tank and gas lines that go under the seat and along the frame. Easy fix . Take plate out like "Timgr" said and mount tank...
I bought mine from Walck's and did it in a day. The only thing I suggest is taking pictures of the routing and where they attach. It helps clean...
Finish getting the side cover off if you haven't already. Put shop towel , plastic, and use you "favorite" method of removing rest of the bolt....
I just replaced my Delco starter on my 225. The old starter had a threaded hole in the side of the case about mid way back of the case for a bolt...
Need the complete heater box, fan motor and controls for a 1971 CJ5 drivers side firewall mount. Motor does not have to work.
The business is called : West Performance 5550 US Hwy. 277 So. Abilene , TX 79556 325-692-5261 Owner : Jarrod West They cleaned the engine up...
I got my F134 done by a shop in Abilene, TX and he did a wonderful job. Just took about 5-6 months. Timing was just about right , due to...
I emailed Herm and he contacted me and verified he had a T14 input shaft for the 225 v6.
Could you have left the cluster gear with dumby shaft laying in the bottom until the main and input shaft was bolted up and then turned the case...
Need an input shaft for a T14 transmission. This will fit to a 225 v-6. The overall length of the shaft needs to be 11.5 inches for it to work.
What size and where did you get those bolts for the new plate you bent? I like those and may change all mine out to those unless they are sheet...
I also ground off the welds holding my 61" dash on . The holes were in the cowl , so I marked and drilled the holes in the dash and attached it...
I had the same problem with the pill and poppets taking mine apart as well. Just took a break and wiggled it differently and "whala" it slid...
I just picked up an early 71' CJ-5 and the emergency brake was missing. Was it like the earlier CJ5's with the T handle on the drivers left side?...
Separate names with a comma.