It's broke for sure. Needs to go back to the re-builder. Nothing here you have done to cause this. When you go back together be sure to put that...
There is something else going on in there? There should not be anything inside the housing that rotates enough to wear the end of the clutch fork....
Many years ago I considered the slope of the engine and found that the intake manifold had a built in slope to it at 4 deg. Then I considered that...
It's always hard to let them go.
2 inch tachometer. Can get new for around $15.00 ebay.
Yes it lessens the torque shock.
That sure ruined that little jeep. Sad..
Welcome to the forum and that Tux is a beautiful jeep. (y)
I was working on 66 TuxIV at SIL shop with new level floor and just happened to measure from the bottom of the frame horn to the floor (front) and...
You need a very big mail box. :lol::rofl:
He sez automatic transmission but show floor shift?
Was likely used as a spacer. Not all coils were the same diameter in the earlier years.
While you are down there already I would check them all and if all are 40 over I would replace all of them just for drill bits. :D
If the points are open during this test then you will read 12v at the coil due no load. If the points are closed then yes you will read +/- 9v.
Depends on how long it has been stored. That paste does tend to dry out and harden over time. Heat kills electronic parts so the heat transferring...
Didn't get to see it. It's been removed.:cry:
Mexican supply sergeant had a field day and cleaned house?
Make sure you have proper vacuum. Your carb power valve operates by vacuum.
Welcome to the forum. You will get lots of help from these guys. Some know 225's inside-out.(y)
Good to go.
Separate names with a comma.