i think that weber is overkill for the f-134.
ebay one i dont trust imitation carbs
i will search for the 1904 and 1100.
just to ask what else we have except the original Carter and the crappy chinese solex that we can fit on the f-head?something that someone...
yes i have a timing light.I found a notch like this and tried to timing the engine with this as default.but very close is some more marks.So im...
there are a lot of hits and notches in that pulley!!If it is in line with the small hole i will identify it and make it visible.
mine is the f-134 double pulley
another one fast question,
i tried to timing my engine with the timing light.The marks are on the engine side good.But on the pulley they are a...
Thanks for the fast answer!!!
Just to ask quick whats the correct orientation for the clutch control tube.There is two levers.One "big" and one "small".which one goes to...
for the F-head on the M38a1.What starters i can use?It's converted to 12v
jeep started!!!!!!!!!!!!!!!!it smokes a little when revving but not something bad.i have now to retorque the gasket and adjust...
cold leak???first time heard about that.thank you very much.
the only trail that found was from a water passage to the first cylinder.front bolts...
removed the head today,1st cylinder was stuck.with little help for a wooden block and a hamme after second hit the piston was free.big amount...
Ok for the pistons.now for the bearings??i hear horror stories about cutted cranks etc.is something like 60 under acceptable??or i need new...
80 over???is that limit safe?i will se tomorrow what the damage is but im making a list of the parts that i need.
after 2 years jeep sitting i was tried to start it again.As you guess the engine f-134 is stuck,tried all combinations with thin...
The jeep is stock.
conversion is 10.6" closed and 16.9" open from hole center to hole center.
I did a measure today without the absorbers and...
I own a M38A1.Please can you tell me the length of the shocks front and rear from hole to hole open and closed?
Mine was 27cm closed and...
i have a m38a1.I want to ask what axle type it have.Tappered or flanged?
And what's the difference between them?
Thank you very much.I will have to found some rims first that will fit.Here in Greece we dont have a lot of parts to choose from US made vehicles...
please can you tell me where can i found complete disk brake conversion kits for the front of M38a1?
Can i use one chamber MC or i have...
Separate names with a comma.