Fino cj you have a good point it could be leaning itself back out at idle. I took a carriage bolt cut it of and filed the square part ontop so it...
So I took fino cj’s advice I sprayed around the intake and carb base with carb choke cleaner to look for vacuum leaks. I didn’t find anything...
I will take the carb off tomorrow, I’m pretty sure they are 51s. I have a brand new set of 53 laying around think that would a mistake skipping...
I have a 160 thermo depends on what kind of driving but somewhere around that 170 180 If I’m putting around fire roads on the interstate which is...
Okay thanks, is that a common problem with todays gas?
I apologize I have to change the post I meant to say lean
Hello everyone, I have a 69 cj5 with a 225 v6 the only upgrade is an HEI. My question is I pulled a few spark plugs and they are completely white...
If you message “metalshaper” through YouTube you can purchase the lubricant he sells for the steering box. When I did my Ross rebuild that’s what...
Okay so the button is in tact and moves pretty freely as I’m guessing it should? old time called it from his first response I later pulled the...
So i got some time to dig a little deeper into my problem as you can see the large washer/spacer that goes behind the backing plate is severely...
[ATTACH] [ATTACH] [ATTACH] [ATTACH]
I did jack it up and spin the drivers tire and the passenger tire spin in the same Direction. I did disassemble the driver side and pull the axle...
The rear never really locked up when I put it in 2 wd in my drive way the drive shaft was turning the from the trans into the diff but it would...
I did check that when I installed them because if that was the case the axle shaft would not slide in all the way because all of the splines have...
So I rebuilt the power lok in my 69 cj5 with a new clutch pack its a Dana 44 19 spline. Everything worked great i drove the Jeep a few times...
Thank you for the offer oldpappy I had an extra hub laying around i used, I sliced the old ones off with a grinder and tapped them out. I finally...
I’ll shave it off and pound it out because I have to believe the extra hub I have is probably better quality than something of poor quality like...
Yeah I ruined a drum trying to pound it out with a BFH. I’m on the fence a new hub is only $65. Thank you to everyone that responded it was very...
What’s the best way to remove the swage a grinder and a chisel?
Old pappy exactly what you said “swaged studs” that’s what they are because if you look close enough where they would attach to the drum they...
Separate names with a comma.