Got the top on and the carb issues fixed. Close to getting it home. [img] [img] [img] [img] [img]
I had some trash in the needle valve and once that was removed the carb has been in it’s best behavior. Also got the soft top installed which was...
Thanks for the kind words. I’ve done a little research on the carb and found some useful info and think I’m headed in the right direction. I’m...
Finally drove it. It took 3 years and two months to get it back on the road. It drove great, brakes worked great, but my carb is leaking gas from...
I thought I did, but I’ll give it another go. [img]
I forgot to say I also had to get my radiator rebuilt. It started leaking when I installed it and really started leaking when I started it. Got a...
I’m close to the end my friends. Just finishing up installing small parts and pieces. I also got the Jeep started after sitting for three years. I...
It is a F134. I know there is a lot of fittings and hose but that’s what I came up with to make it all work. I’ll clean it up a little when I get...
Thanks for the information. I’ll prolly mount a different filter on the fender later but I’m going to give this a shot.
I’m very close to starting up my jeep as I close in on the finish line for the restoration. I have the rigid line running from the gas tank where...
The tail lights are original. They were in dang good shape so I polished them up and put them back on. I don’t have any carpet. It’s rolled on...
Got some more parts and pieces installed. I also have the wheels at the sand blaster and have a paint guy lined up to paint them. My brother was...
Thanks for the pictures. I found some pics of when I tore it down so I had some good pics of the clip for the parking brake but not for the...
It’s me again. I’ve installed the speedo cable and parking break cable which went well, but I’m trying to find out where they are attached to the...
Thanks old pappy. Great explanation. As far as the brake lights are concerned I haven’t really check them yet but I’ll get there next week to try...
All of the work is being done with the engine not running. I have a battery installed in the Jeep and have been testing everything with the key in...
Well I got most of my problems solved I did have some wires on the blinker wire cluster that were not right and I had some wires on the terminal...
Thanks for that info I’ll check that out also.
I have a diagram from walks and in the service manual. I’ll go that route tomorrow and do some testing to make sure I’m getting juice to where it...
I have a thread going on the rebuild section and am getting close to the end but have run in to some problems with the wiring. It’s a 1963 CJ5...
Separate names with a comma.