That’s how it aligned with the notch in the dash.:shrug:
x2 on ebay.
I hate bed liner in jeep tubs. Good luck.
Here is another video I put together after the last snow storm.
I had a plywood template made on the water jet to make sure everything works before cutting the real thing.
Some minor modifications have...
Do a search. This topic has been covered many times.
I’ll do it just to cross it off your list :D
I'll have to look at mine. I forget what they look like.
Export 3Bs had venting windshields.
Where was it located?
I don't think the v8 is factory.
There's some pictures of the mount I built for my t18 in my build thread.
For the paved driveway, I use the pos plow truck. It gets the job done.
For everything else, I use my backhoe. Doesn't get stuck, can...
The early v6 jeeps with T86 transmissions used the standard round transfer case mount. The later ones with a T14 used the 4 cyl. engine mount.
The tail lights could be wired to where the front parking lights are wired to on the headlight switch. Originally, the front parking lights turned...
I have seen them painted as well.
For sale are two repaired alternator brackets. Both were repaired using the 10si alternator in the background to hold the ears in place and then...
Better get on it!
I have taken a pocket screwdriver and used it to bend the female side of the connectors inward inside the plastic to make a tighter fit on the...
The three triangular shaped ones near the outside edge of the drivers side (5/16") are for the blackout light. The two in line half way back on...
Separate names with a comma.