What kind of hook is that?
I'm trying to find drive shaft universal joints for my 1957. The parts book I have is issued in 1959 and the only part number for the universal...
Well I made a post a couple of days ago that I found a Koenig winch bumper. I got the bumper mounted and bolted on. But the front universal joint...
I still works I'm going to use it till it stops working. I just need to find the cage that went around the winch drum now.
Cut the giant homemade bumper off the front of the jeep and started mounting a original Koenig winch bumper. The homemade bumper had to weigh...
Well I fixed it. I let it run while looking down the carb and saw gas flowing out of the high speed/primer circuit with the mixture needle all the...
That would cause a lean issue not a rich one. I fixed the throttle shaft a few years ago.
I'm having trouble with my carter YF 938SD when I turn the idle mixture screw all the way in till it stops the it sill runs. When I turn the screw...
Tractor supply has grade 8 machine thread bolts
What size hole saw did you use?
Koenig had barn doors for the back of there hard tops also.
I'm going to check it this weekend.
Well here is the kicker I used a NOS surplus gear.
That's what happened to me the transfer case is louder than when it had needle bearings.
I've already done the tapered bearing conversion on the transfercase.
I'm late replying but it's only in first, second and reverse.
Does anyone know what the part number is for the speedi sleeve that fits the yokes for a Dana 25 and 44? This is for a early CJ5.
Separate names with a comma.