Which is why I referenced 1980 earlier.:)
Well, it's a Jeeb, says so right there!:rolleyes: Must be some kind of Mahindra, as I'm pretty sure Columbus doesn't have palm trees... The "...
Have you seen this particular one, or are you just parroting what you read on the innerweb?
Here we go.....
If it's really something you have to have, pull the front driveshaft. You'll have all the 2WD low you can handle...……(y)
I have one. PM me your # and I can text you a couple of pics if you are still looking.
That's a name I haven't heard in a long time........ 1980 seems like only a short time ago. Welcome to the club.
A bit farther west than N.Y... Shows to be in Minnesota.
If it ran before you put the parts on it, pull the muffler and make sure its correct and not blocking the port. Then pull the chain off of it and...
May wanna see someone about that.... [ATTACH] :D As long as the "head" fits in the arm, the angle of the dangle shouldn't matter too much. That...
"I have plenty of carbs." Good 938SD?
Hope it's better than it looks. 8 benjys for hinges and badges is a little steep, no?:D I'd be interested in the carb, possibly. [IMG]
For the bolts that hold the hinge to the frame. Also used for some hardtop upper door hinges that mount to the outside of the w/s frame. Usually...
I'll have to look and see what I have left. Had almost all of it at one point........
I think Glenn is on to something. Either a stuck stat, or clog or restriction in the cooling system. Heat up the coolant and it has to go...
Had the manual wiper on my '56 since new, but replaced the w/s frame for one with dual wipers. As I'm a pack rat and saved the original, I'd have...
Pull it, check the crank, and stuff some bearings in it. Plop it back in and drive it. That's the cheap and least amount of non Jeep time you can...
There's a rear shield that protect the rear pinion seal, (sits behind the yoke) that'll make that exact sound when it gets loose. At speed...
I cut up an old magnetic sign into strips, stacked them on either side of the stamping. Used a dense foam roller and ran over the bridge I created...
That spacer lived between the end of the shaft, and the flange on the input shaft of the PTO gearbox. Nut end of the bolts were tucked up in the...
Separate names with a comma.