This is some excellent reading. I love the history!
It's been in the woods and they work as well as I figured. I can't wait to drive it again but the darn salt is everywhere. I hate it. Where are...
My favorite of the ones I had was the 6-71. They would start in the cold really well. I had one with a straight 7 speed and another with a 5...
As an experienced waster of money, I will second the above advice. Figure out the intended use. Figure the best, cheapest and easiest to...
They were stamped 15x6. Not sure if they actually are..
A Dana 20 case will need an adapter behind the sm465 and a new mainshaft. A bell from sbc to sm465 is very easily found for virtually free...any...
I will agree. The rest of your swap idea is great except the 205. Just a big xcase, plus a long adapter. The 20 does have a strong ring gear, but...
I am a fan of the complete frame build. If you tie in the rigid box section to the light open channel, even with fishmouth transitions, it runs...
You are making great progress!
I buy them buy the big pack. They are expensive but they really work well. I like the grinding wheels with the bumps on them. Walter flexcut 15-L 453
For cutoff wheels and grinding wheels I have found Walter to be the best by far. I push hard and they cut fast and last pretty long. I have...
Thanks for all the nice replies! I am pretty happy with it. I have to get around to the power steering next. You would think with the pizza...
And if you do get the Detroit in it, start hunting at the nearest deaf school! I couldn't resist.
You can always get out, do some huntin' and find some nice Jeepy type girl to fill that seat!
[ATTACH] [ATTACH] Alekczander said I should put the hubcaps on.
The rims are finally back. I want to take it on the road but it's covered with salt so around here it stays...
[ATTACH] [ATTACH] [ATTACH]
The body for my CJ6 came from Kelowna (Aqualu) and is fountain green.
The skidders and trucks were the same way, let out the clutch and use the gas pedal like an on off switch. Hold it full throttle till you get...
Check one box for steering...then theres the loud, heavy, underpowered, adapter, framerail strength, and the rest of the boxes to check. Good luck...
Separate names with a comma.